1.
2.Standby
12.Mute
10.Next
7.Next
11.Previous
5.Previous
1
2
3
4
5
6
7
8
9
10
11
12
1.Mode selection(switch USB,
4.Mode selecton(Single press USB,
Micro SD, Radio, & AUX; long press
LED light on/off)
Micro SD,Radio,&AUX)
3.Play/Pause
6.Play/Pause(BT: Long press for 3
seconds, BT docking)
4.Equalizer
5.Repeat
6.Number Selecton(0-9)
7.LED light on/off
9.Volume down
8.Volume up
1 2 345 6 78 9 10 11 12 13 14
13.The charging light is on, the
full light is off
3.
2. 8.
9.Micto SD
11.The DC 5V power input
10.
14.
12.
2.The first time you use the TWS connection, you can select any device as the host
the other as the slave. Press and hold the "Pause playback" button for 3and
seconds,and the USB display flashes to indicate that Bluetooth is connected.
3.Until you hear a "beep" sound, the devices are connected to each other.
4.Turn on the Bluetooth on your device and connect to the MPD877L.the next two
speakers will automatically connect to each other.
Once you hear a beep, the TWS function will be disconnected.
6.In the future use, each time the TWS connection is used, the device connected to
the first time is used as the host (the slave can disconnect the TWS and cannot
connect to the TWS), and the connection to the TWS must be completed in the host.
TWS FUNCTION
1.Turn on two devices of the same model and switch the two devices to Bluetooth mode.
The distance between the two devices is less than 50CM.
5.Disconnect TWS: Press and hold the “ ” button for 3 seconds.Pause playback
Model: MPD877L
POWER
CHARGE
DC 5V
LED.SW TWS CHARGE LIGHT
VOLUME
CONTROL PANEL FUNCTION DECLARATION
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: 1) this device may not cause
harmful interference, and 2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the
equipment.
