MAXSPID BOXSTER BHD/M/W510RM (E/W) User manual

INSTALLATION MANUAL Ver. 1708AUG24
1
BHD/M/W510RM (E/W) BHD/M/W5100 (R/L)
BOXSTER
LED EMERGENCY EXIT LIGHT
SAFETY INFORMATION
•Please read and follow this product guide.
•Servicing and installation of this product must only be done
by qualified electrical personnel.
•Do not expose this product to dripping or splashing. Liquids
may cause failure and/or fire hazard.
•Replace with Maxspid-approved battery only. Incorrectly
replaced battery may cause failure and/or fire.
•Match the polarities of the mains supply with the terminal
block and ensure it is firmly secured. Mismatch may cause
electric shock.

2
INSTALLATION GUIDE
Unit Description
Housing
Charging
Indicator &
Test Switch
Diffuser
& Legend
Control Gear

3
Mounting Guide
Mains Supply Connection

4
Note:
•LED charge indicator will be lit if installation is done properly.
•For first usage, ensure mains supply to the unit is turned on
for 24 hours to fully charge the battery.
*Interrupting the mains supply will discharge the battery.
•For complete maintenance procedures for self-contained
emergency escape luminaires and exit signs, refer to
Singapore Standard 563 Clause 13.
•Installation accessories are not provided unless otherwise
stated.
TROUBLESHOOTING GUIDE
Problem
Possible Cause and Solution
Charge indicator off
No incoming mains supply
Unable to light up in
emergency mode
Battery connector is disconnected
Battery is flat; Ensure the mains
supply is turned on to allow the
battery to fully charge
Duration of lighting up
in emergency mode is
too short
Battery is not properly charged;
Ensure the mains supply is turned
on to allow the battery to fully
charge; Ensure there is no
interruption of power supply for 24
hours