Maytag GAS RANGE User manual

30" DOUBLE WALL OVEN
30" WALL OVEN UNDER COUNTER27" WALL OVEN UNDER COUNTER
27" DOUBLE WALL OVEN
30" SINGLE WALL OVEN
11 1/4" Dia Conduit Access Hole*
2 5/8" Plywood Floor (Must Support 142 lbs)
DIMENSIONS
in cm
27MIN 68.58
24 MIN 60.96
27 7/16 ±1/16 69.69
23 1/2 MIN 59.69
25 1/2 ±1/16 64.77
27 3/4 70.49
26 3/4 67.95
24 7/16 62.07
4 to 33 10.2 to 83.8
27" SINGLE WALL OVEN
A
B
C
D
E
F
G
H
I
5/8" Plywood Floor (Must Support 142 lbs)
11 1/4" Dia Conduit Access Hole*
2
DIMENSIONS
11 1/4" Dia Conduit Access Hole*
25/8" Plywood Floor (Must Support 250 lbs)
DIMENSIONS
in cm
27 MIN 68.58
24 MIN 60.96
49 5/8±1/16 126.05
23 1/2 MIN 59.69
25 1/2 ±1/16 64.77
49 15/16 126.84
26 3/4 67.95
24 7/16 62.07
4 to 12 10.2 to 30.5
A
B
C
D
E
F
G
H
I
5/8" Plywood Floor (Must Support 250 lbs)
11 1/4" Dia Conduit Access Hole*
2
DIMENSIONS
in cm
30 MIN 76.20
24 MIN 60.96
49 5/8±1/16 126.05
23 1/2 MIN 59.69
28 3/16 ±1/16 71.60
49 15/16 126.84
29 3/4 75.57
24 7/16 62.07
4 to 12 10.2 to 30.5
A
B
C
D
E
F
G
H
I
11 1/4" Dia Conduit Access Hole*
25/8" Plywood Floor (Must Support 142 lbs)
DIMENSIONS
in cm
25 63.50
24 MIN 60.96
27 7/16 ±1/16 69.69
23 1/2 MIN 59.69
25 1/2 ±1/16 64.77
27 3/4 70.49
26 3/4 67.95
24 7/16 62.07
36 91.44
1 1/2 3.81
A
B
C
D
E
F
G
H
I
J
11 1/4" Dia Conduit Access Hole*
25/8" Plywood Floor (Must Support 142 lbs)
in cm
25 63.50
24 MIN 60.96
27 7/16 ±1/16 69.69
23 1/2 MIN 59.69
28 3/16 71.60
27 3/4 70.49
29 3/4 75.57
24 7/16 62.07
36 91.44
1 1/2 3.81
A
B
C
D
E
F
G
H
I
J
DIMENSIONS
NOTE: * Hole must be cut as close to corner of cabinet as possible.
** See Dealer for approved cooktops.
in cm
30 MIN 76.20
24 MIN 60.96
27 7/16 ±1/16 69.69
23 1/2 MIN 59.69
28 3/16 ±1/16 71.60
27 3/4 70.49
29 3/4 75.57
24 7/16 62.07
4 to 33 10.2 to 83.8
A
B
C
D
E
F
G
H
I
NOTES
Z Do not block air intake slots along bottom of oven
Y Gas or electric cooktops may be installed over ovens. See
cooktop installation instructions for cutout size.
W Electricalconnectionforelectriccooktopmustbeinadjacentac-
cessible location. Cooktop and wall oven must be on separate
120/240 or 120\208 volt 60 Hz AC circuits.
Built-In 27" & 30"
Electric Wall Ovens
INSTALLATION
INSTRUCTIONS
8101P306-60
(04-99-01)
* * COOKTOPS
SINGLE WALL OVEN
DOUBLE WALL OVEN
403 WEST FOURTH STREET, NORTH ·NEWTON IA 50208
27" WALL OVEN 30" WALL OVEN
in cm in cm
K 4 Burner Gas 2 1/8 MIN 5.4 MIN 2 1/8 MIN 5.4 MIN
K Electric 3 1/8 MIN 7.9 MIN 3 1/8 MIN 7.9 MIN
K Induction 3 1/8 MIN 7.9 MIN 3 1/8 MIN 7.9 MIN

Installing Bottom Trim Piece
Electrical Connections
Unittobeproperlycircuitprotectedandwiredaccordingto
local electrical code and National Electrical Code.
It is advisable that the electrical wiring and hookup be
accomplished by a competent electrician.
120/240 VAC or 120/208 VAC 60 Hz. See serial plate on
front of unit for power requirements.
Theneutralofthisunitisgroundedtotheframethroughthe
green or solid grounding wire. (The green and the white
wiresaretwistedtogetherattheterminationoftheconduit.)
If local conditions do not permit grounding of the neutral,
untwist the green wire and connect the green wire to
groundinaccordancewithlocalcodes. Connectthewhite
neutral to the service neutral.
The chart below recommends the minimum circuit
protection and wire size if the appliance is the only unit on
the circuit.
When installing a 27" walloven under a 30" cooktop some
interference may occur. The following cutout notching of
thesidetrimswilleliminatetheinterferenceofthesidetrim
to the burner box. After cutting, file the side trim edges to
eliminate burrs.
Service
Interruptthesourceofelectricitytotheunitwhenattempting
torepairorservicetheoven. Failuretodothiscouldresult
in a dangerous or even fatal shock.
RECOMMENDED MINIMUM
K.W. RATING CIRCUIT PROTECTION WIRESIZE
ON SERIAL PLATE IN AMPERS (AWG)
15,0 -14.8 20 12
14.9 -16.9 30 10
17.0 -19.9 40 18
10.0 - 11.9 50 18
12.0 - 14.9 60 16
IMPORTANT - SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE 8101P306-60
(04-99-01)
CAUTION
ForEuropeanstylecabinets(flushfront)therequired
clearanceforoperationoftheovendoorisminimum
spacing of 7/8" between the cutout and the door,
hinge or drawer of the cabinet.
Some built-in cabinets may not be wide enough,
due to their construction, to allow this installation.
1. Cut hole in cabinet to mount oven. Cutout in cabinet
should be level and straight.
Note: There are no provisions to level the unit after it
is installed. An oven that is not level could
cause poor baking results.
2. Install plywood floor as shown.
3. Attach unit to the cabinet with four No. 8x1" screws
supplied with unit inside of envelope containing these
instructions. Pre-drill holes in cabinet for attachment
screws using 1/8" drill. Oven mounting holes are
provided in side trim.
4. See instructions at right for electrical hook-up.
5. See Use and Care Manual for operating instructions.