MB QUART MBQT-SUB-1 User manual

Page 1 of 17
Installation Instructions
Model: Honda Talon
Description: Stage 5 Install
Part Number: MBQT-SUB-1
Assembly Time: 60 Min (1-Hour)
No. Component Name Qty
1 8” Subwoofer w/Enclosure (MBQT-SUB-1) 1
2NA2-400.1 Amplier 1
Parts List
1Bojo Tool
2 Panel Clip Pliers
3 10mm open box wrench
4 10mm and 12mm socket
5 ½” socket
6 Rachet
7Small at head screwdriver
8Phillips screwdriver
9 3mm and 5mm Allen Wrench
10 ¼” and ½” drill bit or stepper bit
11 1” hole saw
12 Drill
13 Rotary tool similar to a Dremel
14 Heat Gun or Lighter
15 Crimper
Tools Required
Before you begin, read through these instructions and check that
all parts are present. Always disconnect negative battery terminal,
prior to installation. Please note that MB Quart cannot assume any
responsibility for damage resulting from incorrect installation.

Page 2 of 17
Disassembly
● Remove hood by turning
two latches
● Remove four 10mm bolts, four
push pins, and ve 5mm allen
bolts to remove top of dash
● Remove half mud guard with six
push pins

Page 3 of 17
Disassembly
● Release latch at front of driver
and passanger and lower
cushions to remove
● Remove two 12mm bolts on front
of drivers seat
● Slide driver seat forward and
remove two 12mm bolts on rear
of seat

Page 4 of 17
Disassembly
● Remove drivers seat
● Remove two push pins on front of
passenger seat and then remove
the covers
● Remove two 12mm bolts and two
12mm nuts on the passenger
seat base

Page 5 of 17
Disassembly
● Remove passenger seat from
vehicle
● Using a small at head
screwdriver push in the center
and remove the six clips on the
passenger side
● Remove the ve push pins on the
driver side console like on the
passenger side

Page 6 of 17
Disassembly
● Place gear selector to “H” and
remove the top of the center
console

Amplier Adjustment
Page 7 of 17
● Adjust the NA2-400.1 amplifier gain
and crossover settings as pictured.
NOTE
Gains all to the last “L” on Level
Sub LPF to 100Hz going to “L” on LPF
Subsonic set to 35Hz going to “S” on
Subsonic Boost to 0dB

Wiring Installation
Page 8 of 17
● Plug subwoofer extension
harness into the NA2-400.1
amplier
● Route subwoofer harness down
toward center console going to
the rear of the vehicle
NOTE
Use a sh tape passed from cabin
toward front of vehicle to help pull
wires
● Zip tie harnesses along with OEM
harness

Wiring Installation
Page 9 of 17
● Install power pigtail included with
NA2-400.1 and make appropriate
connections. Amplier plate is
NOT included with subwoofer kit.
● If no buss bar installed, you can
connect to factory wiring but we
highly recommend a buss bar kit
These are available from many
aftermarket companies like XTC
Power Products
● Plug RCA into the NA2-400.2 and
run to the front RCA outputs of
the radio

Subwoofer Installation
Page 10 of 17
● Install four brackets with 5/16
bolts and washers leaving them
loose
● Place subwoofer enclosure under
driver seat area and pass the
harness through small opening
pictured and pull toward top of
center console