McShine LX-710 User manual
EN
Made by ETT Distribution GmbH, Schmalbachstraße 16, 38112 Braunschweig
Reprinting or reproduction only with expressed permission.
Item number: 1530597
Instruction manual
Status: 09/2023
HF / Microwave Motion
Detector McShine „LX-710“
360°, 800W, white, LED compatible
MOTION DETECTOR SETTINGS
• You can adjust the sensor‘s activation based on ambient light with
the LUX rotary switch. When the switch is set to minimum, the sensor
will only operate automatically at night.
• Use the TIME rotary switch to set the time delay, which
determines how long the sensor detects motion.
The sensor can be adjusted from 10 seconds to 12 minutes.
• The SENS rotary switch allows you to adjust the sensitivity of the sensor.
ELECTRIC CONNECTION
• Connect L (brown) and N (blue) from your consumer to the screw
terminals with the lamp symbol ( ).
• Connect the power cable L (brown) and N (blue) to the marked screw
terminals. Isolate the green-yellow conductor.
INSTALLATION
• Remove the cover of the detector. Gently pry open the cover on the side
of the housing using a slotted screwdriver at the designated groove.
• Connect the operating voltage as well as the lamp to be controlled to the
detector following the connection diagram depicted below.
• Secure the detector to the ceiling using the included screws.
• Press the cover back onto the detector so that the edges of the
groove align with each other.
TECHNICAL DATA
Operating voltage: 220 – 240 V/AC
Detection Frequency: 5,8 GHz
Detection Angle: 360°
Range: 1 – 8 m
Dusk Sensitivity: 3 – 2000 Lux
Mounting Heigh: 2 – 6 m
Length: 90 mm
Width: 90 mm
Height: 27 mm
Power Range: 2 – 800 W
EN
Made by ETT Distribution GmbH, Schmalbachstraße 16, 38112 Braunschweig
Reprinting or reproduction only with expressed permission.
Item number: 1530597
Status: 09/2023
CARE INSTRUCTIONS
• Do not use damaged cables.
• Clean only with a soft cloth and neutral cleaning agent.
• Avoid the use of alcohol or cleaning agents containing acetone,
sulfur, beryllium, ammonia, or other solvents.
• Avoid excessive mechanical pressure and heavy soiling.
INTENDED USE
• The product is suitable for indoor use with the purpose of detecting
motion and activating a light source.
• The product must only be used for its intended purpose, as specied
in this user manual!
GENERAL NOTES
• Use only supplied original parts.
• The product has no replaceable parts.
• Do not attempt to repair the product.
SAFETY INSTRUCTIONS
• Check the device for damage before operation.
If this is the case, do not operate the device.
• Please note that any technical modication of the
device immediately voids its approval!
• Keep the user manual for the device.
• Do not drop the device. It could be damaged upon
impact with a hard surface.
• The device must only be installed when the power is off!
• Avoid installation in places with signicant temperature
differences or high humidity.
• Do not leave packaging materials lying around;
plastic lms/bags, styrofoam parts, etc., could become a
dangerous toy for children.
• The device is not intended for children, it is not a toy!
DISPOSAL INSTRUCTIONS
By separating materials, recycling and disposing of old equipment in this way, you
are making an important contribution to protecting our environment.
Packaging can be disposed of free of charge at the appropriate collection points:
• Paper in the paper bin
• Plastics in the yellow bag
• Glass in the used glass container
WEEE disposal note
According to the European WEEE Directive, electrical and electronic
WEEE Directive, electrical and electronic equipment must not be disposed
of with household waste.
Their components must be recycled or disposed of separately, because toxic and
hazardous components can cause lasting damage to health and the environment
if disposed of improperly.
As a consumer, you are obliged under the Electrical and Electronic Equipment Act
(ElektroG) to return electrical and electronic equipment free of charge at the
end of its service life to the manufacturer, the point of sale or to
public collection points set up for this purpose.
Details are regulated by the respective state law.
The symbol of the wheeled garbage can on the product, the operating instructions
and/or the packaging refers to these regulations.
This manual suits for next models
1
Table of contents
