MD SPORTS SG010Y23040 User manual

Assembly Instructions
MODEL
SG010Y23040
www.medalsports.com877-472-4296

This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer.
The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental
damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all
requests for warranty service, please feel free to contact our Consumer Service Department.
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal Sports,
cannot handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE!
MD SPORTS
877-472-4296
www.medalsports.com
Customer Service Toll Free
Please Contact
Mon.-Fri., 9:00 a.m. to 5:00 p.m. EST
For additional resources and Frequently Asked Questions, please visit us at
DO NOT RETURN TO STORE
WE ARE READY TO HELP
English
LIMITED 90 DAYS WARRANTY
SG010Y23040 1(Continued on the next page) www.medalsports.com

This product is intended for INDOOR use only.
Wipe with a clean cloth wrung in water or in a solution of water and a neutral detergent.
Adult supervision is required for children playing this game.
1.
2.
3.
- Not Included
- Included
Adult assembly required.
CHOKING HAZARD - This item contains small parts. Not suitable for children under 3 years.
RECOMMENDED
Power Tools: Set to Low Torque
High Torque: Over Tightened
IMPORTANT NOTICE
WARNING
Do not use or keep
product outdoors. For
indoor use only. No
wet/humid conditions.
Keep away from pets in
assembly area
No children in assembly
area
Phillips Screwdriver
Wrench
Electric Screwdrivers may be helpful during assembly; however, please set a low torque and
use extreme caution.
English
TOOLS REQUIRED
SG010Y23040 2(Continued on the next page.) www.medalsports.com

English
PARTS IDENTIFIER
SG010Y23040 3(Continued on the next page.) www.medalsports.com
Mainframe
1
x1
FOR FIG. 1
PART NUMBER FIG. NUMBER
QUANTITY
PART
PART NAME
6
x2
Air Pump
ACCESSORIES
7
x1
Basketball
7
A1
x4
M6x16mm Bolt
HARDWARE
FOR FIG. 2 FOR FIG. 2
A2
x4
M6 Nut
A3
x1
Wrench
PRE-INSTALLED PARTS
EVA Pad - F M5x5mm Bolt
Scoring Sensor Wire
Electronic Scorer Electronic Scorer Face Plate EVA Pad - A
EVA Pad - B
P2
x2
FOR FIG. 1 P3
x1
FOR FIG. 1 P4
x2
FOR FIG. 1
P1
x1
FOR FIG. 1
FOR FIG. 1
P5
x1
P6
x2
FOR FIG. 1
EVA Pad - C
P7
x1
FOR FIG. 1
EVA Pad - D EVA Pad - E
P8
x4
FOR FIG. 1
FOR FIG. 1
P9
x4
Hook
P11
x2
FOR FIG. 1 P12
x4
FOR FIG. 1
EVA Pad-G
P10
x4
FOR FIG. 1
Needle
Rim
2
x2
FOR FIG. 2
Rim Net
3
x2
FOR FIG. 3
Rim Support Plate
4
x2
FOR FIG. 2
EVA Pad - H
5
x2
FOR FIG. 2

ASSEMBLY
SG010Y23040 www.medalsports.com4(Continued on the next page.)
English
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list page. If any parts are missing, call our customer service.
1.
2.
BEFORE ASSEMBLY
P11
P10
FIG. 1
x1
1
x1
P3
x4
P10
x2
P11
x4
P12
P12
1
P3
ASSEMBLY
REAR VIEW
x1
P1
x2
P2
x2
P4
x1
P5
x2
P6
x1
P7
x4
P8
x4
P9
P1
P2
P4
P5
P6
P7
P8
P9
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed
Pre-installed

ASSEMBLY
SG010Y23040 www.medalsports.com5(Continued on the next page.)
English
FIG. 3
x2
3
3
2
3
2
32
Note: Attach the part with larger meshes
to the rim.
FIG. 2
x2
2
x2
4
x2
5
x4
A1
x1
A3
x4
A2
2
A1
A2
4
5
3
Hangs easily over any
standard size door.

BALL STORAGE
SG010Y23040 www.medalsports.com6(Continued on the next page.)
English
x2
6
6

ELECTRONIC SCORER OPERATION
SG010Y23040 www.medalsports.com7(Continued on the next page.)
English
GAME DESCRIPTIONS
Battery Box: Unscrew the bolt using a screwdriver and open the battery box. Insert 3 pcs 1.5V “AAA” batteries ( not
included) in the sequence of polarity as shown on the inside cover. Then close the cover using a screwdriver. Turn the
power ON using the ON/OFF switch.
BATTERY INSTALLATION
The batteries must be installed according to their correct polarization (+ and -).
If the game will not be used for a long period of time, we recommend removing the batteries.
Please clean the battery contacts and also those of the device prior to battery installation.
a.
b.
c.
REMINDING
Requires 3 pcs 1.5V “AAA” batteries (not included).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.
1.
2.
3.
WARNING
NOTES:
1. Pressing the “ON/OFF” key at any point will turn the game off.
2. After a 5 minute period of inactivity, the game will automatically power off. Pressing the “ON/OFF” key will return the
game.
1. Press the “ON/OFF” key to turn the power on. The default game time is 60 seconds.
2. The game begins after a 5 second countdown.
3. Each player must score on their own hoop - or .
4. All shots are worth 2 points until the final 15 seconds, when each shot is worth 3 points, see how many points you
can get in the timing period.
5. The winner is the player who scores the most points in one minute on their own hoop.
6. If the player needs to continue the game, a ball needs to be shot into the basket or it is restarted, the player can
restart the game.
2
1

English
DISCLAIMER
SG010Y23040 8(The last page) www.medalsports.com
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and (2) This device must accept any interference received,
including interference that may cause undesired operation.
For additional resources, please contact Medal Sports Corp.
1300 Melissa Drive, Suite 124, Bentonville, AR 72712
Toll Free: 877-472-4296
NOTE
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
•
•
•
•

www.medalsports.com