Medialink MWN-USB300N User manual

Introduction:
Thank you for purchasing this Medialink Wireless USB Adapter!
Please follow the simple steps in this Quick Installation Guide to get your computer
quickly connected to your wireless network. For detailed operating instructions, please
refer to the User Manual on the installation CD.
Before you begin, please be sure you have the following:
•
PC with an available USB slot
•Minimum 300MHz processor and 32MB memory
•Windows XP 32-Bit, XP 64-Bit, Vista 32-Bit, Vista 64-Bit, Windows 7 32-Bit, Windows 7
64-Bit
•802.11n or 802.11b/g Wireless Access Point
•
If your wireless network has security enabled, have your Network Key ready so that
you can enter it when prompted at the end of the installation.
(If the network key is entered incorrectly your computer will not fully connect to your network
and will not be able to access the internet. The network key aka WEP-Key, WPA-Key or Password
is case-sensitive.)

Install Driver
Important Note: If you have Kaspersky Anti-Virus and/or Zone Alarm you must follow
these steps before installing this adapter:
Kaspersky:
•Double Click the "K" icon to open the Kaspersky Control Panel
•Select "Settings" at the top
•Select "Options" to the left
•Uncheck the box next to "Enable Self-Defense"
•Save and Close
•Then proceed to Step 2 of this installation
Zone Alarm:
•Completely Uninstall Zone Alarm
•(Uninstall the Medialink Adapter if have already attempted to install it)
•Then proceed to Step 2 of this installation
•You may reinstall Zone Alarm after you have finished installing the Medialink Adapter if
you so choose.

STEP 1. Insert Installation CD
into an available CD-ROM drive. The
welcome screen will appear. If this
screen does not appear, go to your
Start Menu, then My Computer and
then double-click “Medialink”.
If you do not have a CD Rom drive, the
software can be downloaded at
www.medialinkproducts.com/support
NOTE: The following screen shots illustrating the installation procedure may vary
slightly depending on the operating system.
STEP 2.
Click Install Software

STEP 3. Select “I accept the
terms of the license agreement” and
click “Next”.
STEP 4. “Install driver only” will
be selected. Click “Next”

STEP 5. Click “Install” to begin
the driver installation. This may take
several minutes.
STEP 6. Click “Finish” to
complete the installation and restart
your computer.

STEP 7. Insert Your Wireless
USB Adapter Directly Into a USB Port.
(Note: This Medialink Wireless USB Adapter
is only compatible with computers and will
not work when plugged into a TV, Bluray
Player, Printer or any device that does not
run a compatible Operating System.)

Connect to your Wireless Network using Windows
STEP 1.
Windows 7 – Double-click tray icon at the bottom of the screen
to view available networks.
XP / Vista – From the Start menu, click “Connect To”and then “Wireless
Network Connection” to view available networks.
STEP 2.
Select your network from the list and click Connect.
STEP 3. If your router has security enabled, please insert your case-sensitive
network key (aka Wireless Password, WEP Key or WPA Key).
STEP 4. Once your network key (if necessary) is correctly entered, you will be
successfully connected to your network!

Thank you for purchasing this Medialink product!
Please refer to the User Manual on the CD for more details and other settings
Medialink Products, LLC
1951 Old Cuthbert Rd., Ste 301
Cherry Hill, NJ 08034-1411
Technical Support Hotline: [phone]
Technical Support E-Mail: [e-mail]