MedTalk 1327S User manual

1327S
INSTRUCTIONS FOR USE
Gentle and Quick Thermometer with voice
Intended Use
The digital thermometer is intended for the measurement and monitoring of human body temperature.
What is a “ normal ” temperature?
Although the generally accepted “ normal ” temperature reading is 37.0˚C, temperature readings can
vary from 36.1˚C to 37.2˚C and still may be considered “normal ”. Variations in temperature can be
attributed to activities such as exercise, smoking, eating and drinking. Your temperature is lower in the
morning than in the afternoon. Other variations may be due to the location of the temperature reading.
While the oral temperature follows the guidelines previously described, a rectal temperature is
generally 0.5˚C higher. Conversely, an axillary (under the arm) temperature will be 0.5˚C lower.
Product structure
Specifications
Measurement range
32.0˚C~ 42.9˚C
Low temperature display
Temperature<32.0˚C: display: Lo˚C
High temperature display
Temperature>42.9˚C: display: Hi˚C
Display resolution
0.1˚C
Accuracy
35.0˚C ~39.0˚C: ±0.1˚C Other range: ±0.2˚C
Fever beep Sound〔＞37.8˚C〕
Voice report the temperature with Red backlight display
Normal beep sound ( ≦37.8˚C〕
Voice report the temperature with Blue backlight display

Auto power off
1 minute ±60 seconds
Battery
1.5Vx3 , AG13
Operating condition
Temperature: 10˚C ~50˚C Humidity: 10%~95%RH
Storage condition
Temperature: -10˚C ~60˚C Humidity: 10%~95%RH
Net Weight
28g
How to take your body temperature
1. Press ON/OFF button to activate. The unit will beep and display for 1 second with blue
backlight.
2. Then, the last memory will be displayed. You will hear “ please measure ” after 2 seconds and the
device will check itself and display “ Err ” if any problem occurs. At the same time it will speak ” Error,
please measure again! ”, after 60 seconds (±10seconds), it will power off automatically.
3. If self-checking result is normal, LCD will display ” Lo ˚C ” and start measurement, a beep sound will
remind you when the measurement is finished in 8-10 seconds, voice report the result come after with
blue backlight. If your body temperature is too high, the display backlight will be red.
4. If you want to start another measurement, turn off the thermometer and then activate again. It will
power off after standby for about 1 minute (±60seconds). Or press ON/OFF key to shut off directly.
Language selection
Language selection: Under the thermometer is on off mode, press ON/OFF button holding for about 8
seconds till “01” display and release ,then press ON/OFF button to switch between “01“, “02“, “03“,
“04“, “05“, “06“, a beep signal confirms each change. Language code as below for ref.:
Code
01
02
03
04
05
06
Language
German
English
Spanish
French
Russian
Italian
Replacing the battery
The battery in your digital thermometer need to be replaced when “ ” appears in the lower right
corner of the display. Replace the battery with three 1.5V AG13 batteries or equivalent.
To replace the battery,
Open the battery cover
Remove the batteries

Insert new batteries with the positive (+) side up.
Close the battery cover.
Warning: Please properly replace the battery, and keep batteries away from children and heat.
Cleaning instructions
1. Clean the thermometer tip with soft and damp cloth.
2. Don’t wash with water or detergent containing abrasive or benzene.
3. Don’t sterilize by boiling method, gas or steam autoclaves.
Precautions:
1. The thermometer should only be used under the supervision of an adult. It is not a toy for
children. Please keep it out of children.
2. Do not walk, run or talk during temperature taking.
3. Store the unit in the protective case when not in use.
4. Do not store the unit where it will be exposed to direct sunlight, dust or humidity. Avoid
extreme temperatures.
5. Dropping or subjecting your thermometer to strong shocks should be avoided.
6. Do not attempt to disassemble the unit, except to replace the battery.
Ref: UO-8064
FUDAKANG INDUSTRIAL CO., LTD, No. 8, Yinghe Road, Yuanjiangyuan
Management Zone, Changping Town Dongguan, Guangdong, China
FANTRONIC COMPOSANTS Add: Rue Jacques Laurent ZA-Sud-Est-BP11-85150 LA MOTHE ACHARD-
FRANCE Tel:[phone] Fax:[phone]