Mee-go Uno+ User manual

Instruction manual
Carry cot
EN1888-2012

1
2
3

4
5
6

7
8
9

10
11
12

！WARNING
IMPORTANT: Read the instructions carefully before use and keep for future reference.
WARNING: This product is only suitable for a child who cannot sit up unaided.
WARNING: Only use on a firm, horizontal level and dry surface.
WARNING: Do not let other children play unattended near the product.
WARNING: Do not use, if any part is broken, torn or missing.
Only use the replacement parts supplied or approved by the manufacturer.
Do not use the product near heat sources, open flames or dangerous objects that are within reach of the child.
Do not add any mattresses are not approved by the manufacturer.
Before carrying and lifting, make sure that the handle is in the correct position of use.
It could be dangerous to leave your child unattended.
Assembly and preparation of the item must be carried out by adults.
Before use, make sure that all of the attachment mechanisms are connected properly.
Do not insert the fingers into the mechanisms.
It could be dangerous to use accessories which are not approved by the manufacturer.
This product is designed for the children from birth up to a weight of 9 kg.
Take care when adjusting the mechanisms (handle, backrest) with the child present.
Regularly check the handle (or the handles) and the bottom of the carriage to make sure that there are no signs
of breakage or damage.
Instructions for use:
1. OPENING THE CARRYCOT: Turn the handle of carrycot upwards.
2. To open and lock the base in the open position, move the sliders from the centre of the base towards the two
extremities (fig. a) until they click into place (fig. b).
3. HOOD: On the opening zip, a mesh insert allows the parent to monitor the baby (fig. a).
4. COVER: Place the cover over the carrycot; then fasten the zip around.
5. HANDLE: The handle can be locked in the vertical position (fig. a). To lower the handle, press the two side
buttons simultaneously and push it downwards (fig. b). The handle can be used to carry the carry cot and fasten it
onto the stroller (fig. c).
6. ROCKING POSITION: The base of the carrycot is shaped to allow you to rock your child when placed on a flat
surface.
7. SLEEPING POSITION: To turn the carrycot into a non-rocking cradle, extract the 4 feet positioned under the base.
8. ADJUSTING THE BACKREST: The backrest can be adjusted into 3 positions. To access the recline feature, lift up
the mattress and pull the strap to the adjust the bar to the required position.
9. CLOSING THE CARRYCOT: The carrycot can be closed to reduce its bulk. Press and push the tabs of the sliders
beneath the base of the carrycot (fig. a) and move them simultaneously towards the centre of the base (fig. b).
10. To rotate the handle downwards, press the two side buttons simultaneously and push to rotate.
Carrycot assembly onto the stroller chassis:
11.The carrycot can be fixed onto the stroller chassis.
First lift up the carrycot and position it so that the connectors on the carrycot line up with the stroller
connection points. Press down with handle until you hear a "Click".
Always enable the brake on the stroller before fastening and unfastening the carry cot to the chassis.
Ensure the carrycot is properly fastened.
To release it, pull the lever out (arrow _a) and lift the carrycot upwards.

Removing the padding:
12. To remove the padding from the carrycot:
- Release the cover and remove it
- Inside the carrycot you will see two zips running around the top edge. Open both zips to remove the
padding.
Padding cleaning instructions:
Brush the fabric parts to remove dust and hand wash at a maximum temperature of 30° without wringing.
Do not use chlorine bleach.
Do not iron.
Do not dry clean
Do not remove stains with solvents and do not tumble dry.
Product cleaning:
This product requires a small amount of maintenance.
Cleaning and maintenance must only be carried out by adults.
Keep all moving parts clean and if necessary lubricate them with light oil.
Clean the plastic parts periodically with a damp cloth. Do not use solvents or similar substances. Brush the
fabric parts to remove dust.
Protect the product from atmospheric agents: humidity, rain or snow. Extended exposure to sunshine can cause
colour of the product to change.
Store the product in a dry environment.
Contact Mee-go:
Mee-go Ltd
Unit 5, Victoria Mills
Mill Street, Dewsbury
West Yorkshire
United Kingdom WF12 9AQ
www.mee- go.co.uk
British Design