Mee-go Otto User manual

Otto Group 0+ Car Seat
Instruction Manual
Approval according to ECER44-04 with certicate no.: 0442447.
For your child’s safety please read these instructions before use.
Child’s weight 0 - 13kgs.

Important Safety Information
IMPORTANT - KEEP THESE INSTRUCTIONS FOR FUTURE USE.
Please read this instruction manual carefully before use.
If you have any questions concerning the use of this child seat, please do not
hesitate to contact us.
WARNING: DO NOT PLACE A REAR-FACING CHILD SEAT IN THE FRONT SEAT
WHICH IS FITTED WITH AN AIRBAG. DEATH OR SERIOUS INJURY CAN OCCUR.
NOTICE
• This is a “Semi-universal” ISOFIX CHILD RESTRAINT SYSTEM. It is approved to
Regulation No.44,04 series of amendments for general use in vehicles tted
with ISOFIX anchorages systems.
• It will t vehicles with positions approved as ISOFIX positions (as detailed in
the vehicle handbook).
• The mass group and the ISOFIX size class for which this car seat is intended is :
Group 0+ (0-13kg).
EXTREME HAZARD
Do not use in passenger seats equipped with airbags (SRS).
GENERAL
• This child seat can be used for children less than 13kg in weight (Group 0+),
installed rearward-facing using ISOFIX anchorage.
• Use the ISOFIX child restraint system exactly as shown in this instruction
manual.
• Periodically inspect the harness for wear and tear, pay attention to the
attachment points, stitching and adjusting mechanisms.
• In an emergency your child can be released quickly by pressing the red button
on the harness buckle.
• In the event of an emergency it is important that the child can be released
quickly. NEVER LET YOUR CHILD PLAY WITH THE BUCKLE.
• Do not modify this child restraint in any way.
• Always ensure the harness is securely fastened.
CLEANING AND MAINTENANCE.
• Regularly inspect the harness forwear, paying particular attention to
attachment points, stitching and adjusting devices.
• Your child’s car seat must be replaced if it is involved in a collision.
• Please keep this child seat in dry and ventilated place to avoid from damp.
• The car seat can be cleaned with a wet sponge or cloth, using a mild detergent
and warm water and dry thoroughly.
• Never use any solvent, chemical detergent or lubricant on any part of the
car seat.
• The fabrics can be removed for cleaning. (See below).
REMOVING THE FABRICS.
1. Remove the blue plastic lap belts guides from either side of the car seat.
2. Remove the black metal panel underneath the seat which holds the crotch strap
in place.
3. Thread the crotch strap through the front of the seat and remove.
4. Open the press studs around the outer edges of the seat and remove fabrics.
!
30ćP
Hand wash
below 30°C
Do not
bleach
Dry clean Do not
tumble dry
Do not iron

SAFETY WARNINGS!
Failure to follow the instructions contained in this manual could result in serious
injury to your child.
WARNING! DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR AT
ANY TIME.
WARNING! THIS CHILD SEAT CAN ONLY BE USED WITH THE HARNESS FOR
CHILDREN LESS THAN 18KG IN WEIGHT (GROUP 0+,0-13KG).
WARNING! THIS CHILD SEAT CAN BE INSTALLED REARWARD-FACING
USING ISOFIX ANCHORAGE.
WARNING! FOR ISOFIX INSTALLATION: MAKE SURE YOU READ THE CAR
MANUFACTURER’S HANDBOOK.
WARNING! RETAIN THIS INSTRUCTION MANUAL IN THE PLACE PROVIDED ON
THIS CHILD SEAT FOR ITS LIFE PERIOD.
WARNING! DO NOT LEAVE YOUR CHILD UNATTENDED IN THE SEAT AT
ANY TIME.
WARNING! DO NOT PLACE A REAR-FACING CAR SEAT ON THE FRONT SEAT
WITH AN AIRBAG. DEATH OR SERIOUS INJURY CAN OCCUR.
WARNING! THE CHILD SEAT SHOULD BE REPLACED WHEN IT HAS BEEN
SUBJECT TO VIOLENT STRESSES IN AN ACCIDENT.
WARNING! FOR THE REASON OF SAFETY, THE CHILD SEAT MUST BE FIXED
INSIDE THE VEHICLE USING ISOFIX ANCHORAGE EVEN IF YOU DO NOT PUT YOUR
CHILD IN THE CHILD SEAT.
WARNING! ALWAYS MAKE SURE THAT ANY STRAPS HOLDING THE SEAT
RESTRAINT TO THE VEHICLE ARE TIGHT.
WARNING! ALWAYS ENSURE THE HARNESS IS SECURE WHEN FASTENING YOUR
CHILD IN THIS SEAT. ENSURE THE HARNESS IS NOT TWISTED.
WARNING! DO NOT USE ANY LOAD BEARING CONTACT POINTS OTHER THAN
THOSE DESCRIBED IN THE INSTRUCTIONS AND MARKED IN THE CHILD
RESTRAINT.
WARNING! ENSURE ANY LUGGAGE OR OTHER OBJECTS LIABLE TO CAUSE
INJURIES IN THE EVENT OF A COLLISION ARE SECURED.
WARNING! DO NOT ALTER OR MODIFY THIS PRODUCT IN ANY WAY.
ANY REPAIRS REQUIRED MUST BE MADE BY THE CHILD RESTRAINT
MANUFACTURER.
WARNING! THIS CHILD SEAT IS DESIGNED FOR CHILDREN FROM BIRTH
UP TO 9KG.
WARNING! DO NOT USE WITHOUT THE SEAT TRIM AND LININGS.
WARNING! THE SEAT COVER SHOULD NOT BE REPLACED WITH ANY OTHER
THAN THE ONE RECOMMENDED BY THE MANUFACTURER. THE COVER
CONSTITUTES AN INTEGRAL PART OF THE RESTRAINT PERFORMANCE.
WARNING! CHECK FOR HOT SEAT AND BUCKLES BEFORE PLACING CHILD IN
THIS CHILD RESTRAINT.
WARNING! NEVER USE A SECOND HAND CHILD RESTRAINT.
WARNING! NEVER REMOVE ANY WARNING LABELS FROM THE CAR SEAT.
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!

Child Restraint Parts
1. Handle adjuster. 10. Seat belt guide.
2. ISOFIX attachment bar. 11. Shoulder harness slots.
3. Harness adjuster strap. 12. Instruction manual storage pocket.
4. Harness adjuster button. 13. ISOFIX attachment bar.
5. Fabric cover. 14. Lap belt guide.
6. Harness buckle. 15. Foam padding.
7. Shoulder straps.
8. Carry handle.
9. Hood.
1. Install position of the child seat in vehicle using ISOFIX.
Correct tting/suitable. Incorrect tting/not suitable.
This child seat is suitable for xing into the seat positions of the cars equipped
ISOFIX anchorage that are tted in accordance with European standard (ECE44 or
equivalent standard).
IMPORTANT:
The child seat must only be installed using ISOFIX anchorage. Refer to your vehicle
handbook.
2. Install position of the child seat in vehicle using the seat belt.
This child seat is suitable for using in a vehicle with a 3-point static safety belt.
WARNING:
Only use in the passenger seat of a car with an air bag which is disabled.
Only use in the rear of the vehicle with a 3-point static safety belt.
!
!
!
!
WARNING! Only use on this seat if ISOFIX
anchorage is equipped.
1
2
15
15
3
4
5 6
7
8
9
10
11
13
14
12
!
!

3. Checking the correct use of the shoulder straps.
Always check that the shoulder straps are at the correct height for your child. The
shoulder straps should always be through the slots which are closest to the top of
your child’s shoulders.
4. Operating the harness buckle.
1. Put the two metal sections of the buckle connectors together.
2. Slot the two buckle connectors into the slot in the buckle until they ‘click’
into place.
3. Check the harness is correctly locked by pulling the shoulder straps upwards.
To release the harness; press the red button on the buckle, the two metal sections
will release.
CAUTION! Never let your child play with the buckle.
5. Adjusting the harness.
1. To slacken the harness press the button on the front of the seat and pull the
harness shoulder straps forwards.
2. Tighten the harness by pulling the harness adjuster strap at the front of the seat.
The harness needs to be a snug t without causing discomfort to your child.
CAUTION! Adjust the harness for a snug t every time you place your child in
the seat.
1.
1.
2.
2.
3.
Click
Too low Too high Correct

6. Installing the car seat using the 3-point safety belt.
1. Push the car seat rmly against the backrest of the vehicle’s seat.
2. Route the lap belt through the lap belt guides on both sides of the child seat and
fasten it into the buckle until you hear a click.
3. Feed the diagonal section of the seat belt through the diagonal belt guide on the
rear of the child seat.
4. Ensure the seat belt is tight by pulling rmly upwards. Ensure the seat belt is not
twisted.
Caution: Ensure the vehicle’s seat belt is securely engaged, the seat belt is tight
and is not twisted before use.
For installation using the ISOFIX Base please see instruction manual in the
ISOFIX Base packaging.
7. Adjusting the handle.
To adjust the car seat handle press the red buttons on either side of the car seat
handle and adjust into the required position.
The handle has 3 positions:
1. When installed in a vehicle.
2. For carrying.
3. For removing baby from the seat.
CAUTION! Always ensure the seat handle is clicked into place and your child is
fastened in the seat correctly before lifting.
Should you nd a defect with this product:
Please keep your original receipt of purchase safe as it will be required should you
unfortunately nd a defect. The receipt must show the date of purchase clearly.
Should you nd a defect with this product you must rst contact the original place
of purchase. Repairs to any part of this product do not extend the warranty period.
Do not return your product direct to the manufacturer.
Warranty information:
For full warranty details please visit http://www.mee-go.co.uk/warranty/
To register your warranty:
Please visit http://www.mee-go.co.uk/register/
1.
3.
2.
Click!
4.
1. 2. 3.

Mee-go Ltd
Unit 5, Wharf Street,
Dewsbury WF12 9AU
T: 01924 485552
E: [email protected]o.uk
W: www.mee-go.co.uk
Copyright Mee-go Limited
November 2016.