MEGASTEK GT5C User manual

Long Standby GPS Tracker
(GPS+GSM+SMS/GPRS)
User Manual
(GT5C)
This user manual has been specially designed to guide you throughthe functions and features
of your GPS vehicletracker.

Content
1. Products Components and Port Definition ............................................................................ 3
1.1 Product Introduction..................................................................................................................... 3
1.2 Product Configuration List.......................................................................................................... 4
2. Specifications and functions.......................................................................................................... 4
2.1 Specifications ................................................................................................................................... 4
2.2 Functions........................................................................................................................................... 5
2.3 Setting and installation................................................................................................................. 6
3. after-sales services ............................................................................................................................. 7
3.1 Indicator Light State .............................................................................错误!未定义书签。
3.2 Attention............................................................................................................................................ 7
3.3After-sale service ........................................................................................................................... 7

1. Products Components and Port Definition
1.1 Product Introduction
Name
Long Standby GPS Tracker
Type
GT5C
Size
L77*W41*H27mm
Long stand by device low power consumption to 2µA when standby locate one times a day can lifelong
for three years <over than 1200 pcs data> small and smart mainly using in financial rental and private
car areas.

1.2 Product Configuration List
Packing List
No
Name
quantity
Unit
1
GT5C
1
Pc
2
Packagebox
1
Pc
Optional list
No
Name
quantity
Unit
Remark
1
4PIN wire
1
pc
Used for setting parameter
2
magnet
1
pc
Either-or
3
Velcro
1
pc
2. Specifications and functions
2.1 Specifications
No
Item
Specifications
1
Working voltage
DC 3V
2
Working current
60-80mA @3V
3
Standby current
<3.5uA
4
Size
L77mm*W41mm*H27mm
5
Location Way
GPS
6
LocationAccuracy
<10 meter
7
Communication Network
GPRS
GSM:800/900/1800/1900 MHz Quad-band
8
Communication way
TCP
9
Working temperature
-25℃+75℃
10
Storage temperature
-40℃+85℃
11
weight
100g
12
Battery life
3 years (CR123A)

2.2 Functions
FunctionDetails
Function Illustration
Alarm Mode
Can set wake-up time 4 times each day, would wake-up
automatically in
the setting time and after sent the Data then go
into sleepingmode
Timer Mode
Sent the data at one fixed time and sent the location data in the
setting
time
Week Mode
Can set a time point and one day or several days in one week to
sent the
data and then go into sleepingmode
LBS tracking+ GPS
tracking
When GPS cannot get the signal ,the LBS tracking would start
working automatically
Serial port set-up
Can set IP and port ,APN, Equipment number, correcttime, alarm
mode ,timer mode, week mode
Message set-up
Can set IP and port, APN, Equipment number, alarm mode R,
timermode. W, week mode
Message inquiry
Return back to referencesetting
Message to correct
time
Use the mobile edit (C: TIME) send to the terminal equipment,
afterthe
terminal get the message and would apply time correct
to platform automatically.
Tamper alarm
When the equipment detected the light turn to bright, the
equipment will send an alarm message to the platform.
Anti-fake-LBS
location
Then device will refuse to connect to the fake-LBS locate when
detected
Data send explanation
1.
After battery finish installation. GPS Mode start searching the signal, Within 4 minutes, the GPS
module will be turned off immediately and start dialing. GPS mode will go into sleeping mode after 8s once
sending the last data. If GPS mode has not been positioned, it will start dialing after 4 minutes.
2.
For RTC awaken or Sensor awaken, GPS mode will wait for location no more than 150
seconds,
otherwise it will start to send data by dialing immediately, if GPS mode can’t locate within
150s. Time
modewhich is set 7 to 30 minutes will quick located within 90s.
3.
Time mode which is set 7 to 30 minutes will go into sleeping mode within 3 minutes. The
device
won’t go into sleeping mode if it is set for 1~6 minutes. Other modes need 6 minutes
for going into
sleeping mode.

2.3 Setting and installation
2.3.1 Installation
Open the device and put on SIM card
2.3.2 Com Port Setup
Com Port No.
Choose right com port and open it
Communication
IP
Set the needed IP and Port
APN
Set the needed APN
Equipment No.
Setting the equipment NO.
Time correct
Can correct time (Remark: after equipment power off ,the time would not be
kept)
Alarm mode
Can set up alarm and to send back the data, can set 4 times atmost
Timer mode
Choose close then adopt alarm mode ,choose open ,then the date send back
according to the setting-up time
Week mode
Choose close then adopt alarm mode ,choose open ,then the date send back
according to the setting-up week time
Alarm switch
Choose tamper alarm switch open or close
Setting
After setting the parameter, then click setting, after setting succeed ,then
remind you setting succeed ,otherwise remind you settingfailure
Read
Click read and confirm if the parameter you read is same as yoursetting-up
Set by Computer(use USB line make the device connect with computer)

3. after-sales services
3.1 Indicator Light State
GSM Indicator light (Red)
Light-off long
GSM abnormal or the light broken
Light quickly
GPRS no signal or cannot register the net
Flash slowly (lighter after 2 seconds
and dark aftertwo seconds)
GPRS have signal, but not on-line
Flash fast (2 times/second)
terminal equipment getonline normally
GPS Indicator light (Yellow)
Light-offlong
GSMmodebrokenorgointosleepingstate
Light long
terminal equipment work abnormal
Flash slowly (1 time/second)
have signal but location failure
Flash slowly (3 times/0.2 second)
terminal equipment get into sleeping mode
Flashquickly (2 times/second)
terminalequipmentlocation succeed
3.2 Attention
1. Stay away from water
2. Working temperature is -20 to 70 centigrade, please cut off power if the temperature is over this
range.
3. When vehicle is in underground parks, tunnels or garage, maybe GPSsignal willnotverygood.
Communicationnetworkblindareawillbecausedandcannot monitor vehicle. When the car is out of that
area, it will working goodautomatically.
4. Please not repair by yourself when the device not working properly.
3.3 After-sale service
1. During the one-year warranty, please feel free to contact us if there is any problem or damage not
caused by human factors.
2. Not maintenance:
(1) Client dismantled privately
(2) Force majeure (floods, accidents, etc.)
3. More than one year damage or faulty maintenance will need to pay for raw material.
4. Free to provide customers with the purchase, use, installation and other consultation and technical
services.
Table of contents
Other MEGASTEK GPS manuals