MEI EC6000 Manual

EC6000 Changegiver - Operators Guide
MEI, 2008 Page 1 Rev: G2
EC6000 CHANGEGIVER - OPERATORS GUIDE
OVERVIEW
1. The Reject Lever is used to open the
Discriminator to clear obstructed coins.
2. Discriminator and Separator assembly –this
part checks whether a coin is accepted or not
and then the Separator routes it to the
3. MMI –(Man Machine Interface) contains
buttons for configuring the unit and three LEDs
allow troubleshooting whether they are lit or
flashing.
4. Cassette –used for coin storage.
5. Dispenser Module –used to dispense coins
from the cassette tubes.
6. Discriminator/Separator Assembly Release
button.
CASSETTE REMOVAL
1. Lift black Release mechanism.
2. Tilt cassette forward and lift out.
CASSETTE FILLING
Press Button
Sequence
Description / (Action)
Float coin tubes / (Insert coins then press button)
Coins must be inserted through the EC6000 Validator.
A
4
3
5
2
1
6

EC6000 Changegiver - Operators Guide
MEI, 2008 Page 2 Rev: G2
COIN JAMS
The EC6000 Coin Path is fully accessible. No screwdrivers are required.
To open up the full coin path to check for jammed coins, remove the cassette, open the validator and
open the display panel by releasing the locking clip on the left hand side.
CLEANING
Use only a soft damp cloth, a small light brush and dry cloth. DO NOT use solvents or abrasives.
Display Locking Clip Release
Clea
n
Clean
Clean
Clean