meitav-tec IDK360 User manual

Sensitivity
adjustment
Rotate counter clockwise
to open
Cut-off time
adjustment
12
1
Red LED
Terminals
Cables
threading holes
www.meitavtec.com | [e-mail]
1
Min.
10 Sec.
30
Min.
20
Min.
10
Min.
IDK360 – Ceiling Mounted Microwave Occupancy Detector
Cut-off delay time
Rotate the outer ring counter clockwise and separate
it from the base.
Use the right knob (TIME) to adjust delay:
Extend the delay - Rotate clockwise
(30 minutes max.)
Reduce the delay - Rotate counter clockwise
(10 seconds min. - default)
2Adjusting the sensitivity
If required – repeat the steps above to separate the outer
ring from the base.
Use the left knob (LUX) to adjust the sensitivity:
Higher sensitivity - Rotate counter clockwise (default)
Lower sensitivity - Rotate clockwise
HF System: 5.8GHz CW radar, ISM band
Transmission Power: <10mW
Power Sourcing: 12VDC
Cut-off delay: 10sec.~30min. - adjustable
Detection Range: 360°
Installation height: 1.5~3.5m
Detection Distance: 1-8m radius - adjustable
Sensing indicator: Red LED (can be cancelled)
Polarity: Normally open/close – selectable
Dimensions: Diameter 105mm, Height 25mm
TIME
5
Min.
LUX
Sensitivity High
Low
Pg. 1

Wiring
diagram
Rotate the outer ring counter clockwise and separate it from the base
Release the cables threading holes.
Install the sensor using the two attached screws.
Dry
contact
Supply
12VDC
Sensor
installation
3
RELAY12V
Enable/Disable the Red sensing indicator
Flip over the sensor, take out the three screws and separate the back panel.
Gently, pull the electronic circuit out.
Using the top (LED) 2-position selector, select between:
ON (left position) – LED indicator active (default).
OFF (right position) – LED indicator disabled.
4Selecting sensor polarity
If required – repeat the steps above to separate the back panel.
Using the left (SWITCH) 2-position selector on the top, select between:
NO (left position) – Contact closed when occupied.
NC (right position) – Contact open when occupied (default).
Take out the three screws Sensing indicator
selector
Polarity selector
3
4
Red LED
Flip over and pull
the electronic circuit
Pg. 2
www.meitavtec.com | [e-mail]