6 GB/IE/NI
Keep away from ponds and other water reservoirs.
Install the LED rope light 1at least 2 metres
away from water containers. Avoid place that
might flood after heavy rainfall.
If using the LED rope light 1outdoors, make
sure it is connected to a socket which is protected
with a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30mA.
The LED rope light 1is protected against
splashes of water (IP44) as long as the socket
meets the minimum protection standard.
Make sure the LED rope light 1is not laid
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
Do not pull the LED rope light 1and make
sure it is laid down properly so that no one
walks or trips over it.
If in any doubt about the safe installation or
use of this product, please consult a qualified
electrician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The LED rope light 1can be installed on all
normally inflammable surfaces with the enclosed
mounting parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or water
lines located where you wish to drill. Check with
a cable and pipe locator if necessary before
you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the LED rope light 1. If you are in any doubt,
consult an electrical specialist for advice.
Do not use sharp and/or pointed objects such
as wire, nails or fasteners for mounting.
Do not attach any additional objects to the
LED rope light 1.
Avoid excessive bending of the LED rope
light 1. This can damage the insulation.
The bending radius of the rope must not fall
below the following value: rope diameter
between 10–14mm: 2cm.
Avoid excessive heating of the LED rope light 1.
A maximum of two sections of rope may cross
or run parallel to each other.
Installation
Note: Remove all packaging materials from the
product before use.
First, please unroll the product before use.
Note: The LED rope light 1can be mounted on
all surfaces officially classified as being of “normal
flammability” by means of the supplied attachments.
Please fix the LED rope light 1on the desired
surface and fix the product by attaching it with
the help of the included cable ties 3.
Alternatively, you can also mount the product
by using the included attachment clips 2. Firstly,
place the attachment clips 2in a sturdy sur-
face and fix them with the included screws 4
by using a crosshead screwdriver. Once the re-
quired attachment clips 2have been attached,
you can press LED rope light 1into the open-
ing of attachment clips 2. You may further use
the cable tie 3to secure the LED rope light
1onto the attachment clips 2if need.
Use
Plug the mains plug into the socket.
The lighting is switched on.
To turn the lighting off, remove the mains plug
from the socket.
Timer function
To switch on the timer function, press the timer
button 5after the product is connected to the
socket of power supply. The timer button 5
will light up when the timer function is activated.
The product lights glow permanently for 6 hours
and will be followed by a subsequent pause of
18 hours. Afterwards, the product will light up
again at its designated turn on time for 6 hours
followed by a subsequent pause of 18 hours.
