Melita NexTV User manual

WiFi Self Installation Guide
Best practice:
Getting the best from your WiFi connection
1. Make a clear path
Your WiFi signal can be weakened if there are obstacles (such as walls and
furniture) between your NexTV Decoder and your modem.
If you experience issues with NextTV, try moving either your NexTV
Decoder or your modem to improve the WiFi signal.
If you still have problems you will need an Ethernet cable to connect to the
internet via your modem.
For further assistance please visit: help.melita.com/category/nextv/
For updates and new features please go to melita.com/nextv
Melita NexTV
Ethernet Cable
2. Avoid interference
Make sure that your NexTV Decoder and
your modem are positioned away from
electrical equipment, such as microwave
ovens, and neighbouring WiFi signals.

To enjoy all the interactive benets of NexTV you’ll need to connect your NexTV
Decoder to the internet via your Arris modem.
The simplest way to connect to the internet via WiFi is to use the WPS (WiFi
Protected Setup); this leaet explains how.
You’ll rst need to connect your NexTV Decoder to your TV.
1
2
3
4
Check that your home internet connection is working, for example by checking
the WiFi signal on your smartphone, computer or other device. Make sure that
NexTV decoder is within range of your WiFi signal.
Use the HDMI cable provided to connect your TV to your NexTV Decoder
using the socket marked HDMI.
Use the RF cable from your existing set top
box and connect it to the back of the NexTV
Decoder, using the socket marked RF IN.
Turn on your TV and NexTV Decoder
You’re now ready to establish the WiFi connection between your
NexTV Decoder and your modem. Use your remote control to scroll through
the NexTV interface and activate the
WPS as follows.
Press OK on remote
Go to My World
Go to Settings
and press OK
Go to Network
and press OK
Scroll down to Active
Interface, select interface
and press OK
i. Select WiFi and press OK
ii. Scroll down and select Connect to WiFi
iii. Select Connect with WPS
iv. Press the WPS button
at the back of the NexTV
Decoder and within 30
seconds press the WPS
button on your modem for
5 seconds. The blue WPS
light will come on.
A pop up box will show on
your TV screen to conrm
you have connected
successfully.
WPS button
HDMI
RF IN
NexTV Decoder
NexTV Decoder
Arris Modem