Mellanox Technologies 90Y3572 User manual

Mellanox Technologies Inc. 350 Oakmead Parkway, Sunnyvale, CA 94085 Tel: [phone] Fax: [phone] www.mellanox.com
90Y3572 Installation Guide
Document Number
3426
Rev 1.0
Before you install your new Mezzanine card, check to make sure that there is no visible damage that may
have occurred during shipping.
Note: If the card looks damaged contact your customer representative immediately.
Physical Installation
Note: This device is intended for use only with UL listed IBM BladeCenter units.
ESD Connection
Before starting any procedure:
1. Put an ESD prevention wrist strap on your wrist, and make sure there is good contact between your
body and the strap.
2. Plug the other end of the wrist strap to a valid ground. Make sure that this is a tight fit.
Installing the Card
3. Remove the blade from the server.
4. Set the blade on your work table.
5. Remove the cover from the blade. Press on the two blue squares (one on each side of the blade)
and lift up while pressing in.
6. Pull the cover forward and it will come off.
Press on the two blue square. There is an
identical one on the other side.
Hinge holding the
cover The mezzanine card
Release lever
Connector fully inserted
into its holder

46M6001 Installation Guide
Mellanox Technologies
Rev 1.0 2
7. Lift up on the release lever until it is vertical.
8. Lift gently on the card while pulling the card from the plastic holders.
Note: Beware the parts in the blade may be very hot!
9. Insert the new card into the plastic holders. The card will lay almost flat when inserted cor-
rectly. Make sure that the pin connector is properly inserted. See picture below.
10. Press the card firmly into place. This may take considerable pressure, and you should feel the
card snap in.
11. Replace the blade cover. Make sure that the cover snaps into place.
12. Insert the blade into the server.