Mercury MOTORS 25HP+ User manual

MOTORS 25HP+
Install Guide for Motors 25HP+
WB.M25+.02
https://support.legendboats.com/ 1
Confirm with the Mercury Marine Installation manual supplied with the motor, the correct lifting
device required prior to hoisting the motor. Ensure proper mounting template is used based on
Boat Model.
ATTENTION
TOOLS REQUIRED
1/2” Drill Bit
7/16” Wrench
#3 Phillips Bit
Silicone
3/4” Impact
Socket
9/16” Wrench
Drill Impact
Wrench
C-Clamp
Safety
Glasses
Tape Measure

MOTORS 25HP+
Install Guide for Motors 25HP+
WB.M25+.02
https://support.legendboats.com/
2
STEP 1
STEP 2
STEP 3
Remove the center pre-installed bolt located
on the Transom to accommodate the Motor
Template.
Mount the Motor Template onto the Transom
of the Boat
Align the right edge of the template with the
center keel dimple and clamp in place.
Confirm template location with Lead Rigger/
Shop Foreman.
Do not drill pilot holes prior to confirming
template location with Lead Rigger/Shop
Foreman.
ATTENTION
Ensure Motor Template is sitting flush with the
Transom.
NOTE
Riveted hulls may require a screw on the
transom cap to be removed for properly
mounting the template.
NOTE

MOTORS 25HP+
Install Guide for Motors 25HP+
WB.M25+.02
https://support.legendboats.com/ 3
STEP 4
STEP 5
STEP 6
Using the 1/2” drill bit, drill through the
Transom into each hole of the Motor
Template.
Remove the Motor Template from the
Transom and re-install the bolt from Step 1.
Review Motor Crate to locate any damage
or potential issues with the Motor. Uncrate
Motor and review again for any damages.
If there is damage to the Motor or Crate, review
with Lead Rigger/Shop Foreman.
ATTENTION

MOTORS 25HP+
Install Guide for Motors 25HP+
WB.M25+.02
https://support.legendboats.com/
4
STEP 7
STEP 8
Review the Legend Motor Guide to
determine the mounting hole location of the
Motor onto the Transom.
Refer to the Mercury Marine Installation
manual included with the Motor for installing
the motor.
Confirm with the Mercury Marine Installation
manual the correct lifting device required
prior to lifting the motor.
QR Code directs to Mercury Owners
manuals. Continue to Americas - United
States site for reference documents when
prompted.
Motors greater than 175HP require a 3/8” gas line
for installation. Motors less than 175HP require a
5/16” gas line for installation.
ATTENTION