Mesqool CR1001 User manual

- 01 - - 02 -
Chapter 2 POWERING ON
Insert the 2 included holders into the hole on the back to avoid being
knocked over.
1. Install 2pcs 1.5V “AAA” size batteries to the proper terminals in the
battery compartment to memorize the time setting in case of power
outage.
NOTE: Batteries(not included) don't support time display but can trigger an
alarm in case of AC power failure
2. Connect the adapter line to DC jack , then plug into a 100~240V AC wall
power outlet.
Chapter 1 LOCATION OF CONTROLS
1. TIME/12-24H/MEN/M+ Button 2. HOUR/TUNE- Button
3. MINUTE/TUNE+ Button 4. DIMMER/DST Button
5. OK/SNOOZE/SLEEP Button 6. ALARM 1/ALARM OFF Button
7. ALARM 2/ALARM OFF Button 8. RADIO ON/OFF Button
9. PROJECTION ON/ FLIP/OFF Button 10. VOLUME+ Button
11. VOLUME- Button 12. PM INDICATOR
13. DST INDICATOR 14. ALARM 1 BUZZER INDICATOR
15. ALARM 1 RADIO INDICATOR 16. FM RADIO INDICATOR
17. ALARM 2 BUZZER INDICATOR 18. ALARM 2 RADIO INDICATOR
19. FOCUS RING 20. BATTERY DOOR
21. USB PORT 22. DC JACK
23. FM ANTENNA 24. SPEAKER
25. HOLDER ( x 2pcs)
CR1001 Alarm Clock with Time Projection
CREATE YOUR PERFECT SLEEP ENVIRONMENT Mad e in China
Http://www.mesqool.com
Contact our experts
[email protected]
Version 3.0
20 22 23 21
24
25
10
11
Chapter 3 TIME SETTING
Before time setting, check whether FM radio is closed, if not, press
button again to turn off radio.
1. Press button once, display starts flashing.
2. Press button to set the hour. press button to set
the minute.
3. Press button to save time or wait for another 5 seconds to
confirm automatically.
To change 12H/24H time format
Hold press to change 12H/24H time format.
SNOOZE
SLEEP
HOUR
TUNE-
MIN
TUNE+
RADIO
RADIO OFF
123456789
12
13
14
15
16
17
18
19
SNOOZE
SLEEP
DST
SNOOZE
SLEEP
TIME/12-24H
MEN/M+
TIME/12-24H
MEN/M+

- 05 -
- 04 -- 03 -
Chapter 6 USB CHARGING
Plug charging cable into device such as phone or tablet.
Device can charge both your phone or tablet at the same time.
The maximum charge current is 1 Ampere.
This product features convenient dual alarms. Each alarm function can be set
independently, with optional radio alarm sound or buzzer alarm sound.
NOTE: Radio channel you listened last time will be the default radio alarm.
Setting Alarm 2 is the same as Alarm1.
Turn off Alarm
When alarm goes off:
1. Press button to temporarily turn off alarm for 9 minutes.
Alarm will ring every next 9 minutes.
2. Press button to turn off alarm for 24 hours.
The alarm indicator or is still on, which means alarm is still
activated and will ring after 24 hours.
3. Cancel Alarm
Repeat button until or indicator will disappear from
the display, which means alarm is completely turn off.
Turn off Alarm 2 is the same as ALARM 1.
SNOOZE
SLEEP
Indicator means buzzer alarm. Indicator means radio alarm.
Both indicators are off means alarms are inactive.
Chapter 4 ALARM SETTING
Chapter 7 RADIO SETTING
Turn ON or OFF radio
Press button to turn on, press button again to turn off.
Manual Tuning Radio Channel
Repeat or button to tune into the desired radio channel.
Each press button, FM frequency will tune up by 0.1MHZ.
Each press button, FM frequency will tune down by 0.1MHZ.
Auto Scanning Radio Channel
Hold press or button for more than 2 seconds to start
auto scanning.
Scanning will stop automatically once received a available radio channel.
Adjust Radio Volume.
Repeat button to increase the volume.
Repeat button to decrease the volume.
FM frequency: 87.5 MHZ ~ 108MHz, 87.5MHz preset as a default.
Auto Preset Channel Store.
After radio turn on, hold press button to start preset store, radio
will store available channel to P01......P20.
Manual Preset Channel Store.
When radio receives the channel which you desire, hold press
button, display will show the preset position number, please or
button to select the preset position number which you desire,
then press to confirm your selection.
RADIO
RADIO OFF
HOUR
TUNE-
MIN
TUNE+
MIN
TUNE+
HOUR
TUNE-
HOUR
TUNE-
MIN
TUNE+
VOL+
VOL-
HOUR
TUNE-
MIN
TUNE+
SNOOZE
SLEEP
Repeat button to adjust the brightness of display for your preference.
There are 5 dimmer levels.
Hold press button to switch DST function, hold press button
again to turn off DST function.
Chapter 5 DIMMER & DST
DIMMER
DST
DIMMER
DST
Preset Channel Recall
After radio turn on, repeat press button to switch preset store
channel, after you select the channel which you desire, wait more than 3
seconds, radio will confirm your selection.
Chapter 8 SLEEP TIMER SETTING
The SLEEP timer function allows the radio to play in blocks of 10, 20, 30,
40, 50, 60, 70, 80, or 90 minutes before turning off automatically, so you
can enjoy falling asleep when listening to the radio.
1. After radio turn on.
2. Press once ,display show
3. Repeat to select your desired sleep time. Sleep time show
on the display in sequence as 60 > 70 > 80 >90>80.......> 20 > 10 > OFF
4. Wait for 2 seconds, radio will confirm your selection.
SNOOZE
SLEEP
SNOOZE
SLEEP
Chapter 9 PROJECTION MODE
1. Press Projection mode button to turn on projection.
2. Press button once again to flip the projection time reversely.
3. Press once again to turn off projection.
4. Rotate focus ring to adjust clarity of projection image.
PROJECTION
ON/FLIP/OFF
Note: 1. Best projection distance is between 1.5 to 3.0 meters.
2. Projector is a common LED light. So the projector is not visible in bright
environment.
3. If projection numbers are fuzzy,please rotate the focus ring (17) to adjust
proper angle for clear projection image.
- 06 -
DIMMER
DST
RADIO
RADIO OFF
ALARM1
ALARM OFF
ALARM1
ALARM OFF
Set alarm wake by buzzer
1. Press once button,buzzer alarm indicator will light up,and
display start flashing.
2. Press button to set the HOUR, press button to set the MINUTE.
press button or wait for 5 seconds to confirm alarm time
automatically.
ALARM1
ALARM OFF
HOUR
TUNE-
MIN
TUNE+
SNOOZE
SLEEP
3. While Display shows alarm volume and speaker play
cooresponding the volume level. press or button to adjust
alarm volume.
4. Press button to save alarm setting or just wait for another
5 seconds to confirm automatically.
VOL+ VOL-
SNOOZE
SLEEP
Set alarm wake by FM radio
1. Double press button,buzzer alarm indicator will light up,and
display start flashing.
2. Press button to set the HOUR, press button to set the MINUTE.
press button or wait for 5 seconds to confirm alarm time
automatically.
ALARM1
ALARM OFF
HOUR
TUNE-
MIN
TUNE+
SNOOZE
SLEEP
3. While Display shows alarm volume and speaker play
cooresponding the volume level. press or button to adjust
alarm volume.
4. Press button to save alarm setting or just wait for another
5 seconds to confirm automatically.
VOL+ VOL-
SNOOZE
SLEEP
PROJECTION
ON/FLIP/OFF
PROJECTION
ON/FLIP/OFF
TIME/12-24H
MEN/M+
TIME/12-24H
MEN/M+
TIME/12-24H
MEN/M+