Metro DataVac STARSYS SX595 User manual

PART # SX595
Assembly consists of (1) Hospital Grade, 6 outlet, 15-ft Power Strip, (1) Cord Wrap,
(1) Hardware Bag
1. Both the OVERBRIDGE AND THE POWER STRIP must be installed as ONE ASSEMBLY
onto the Starsys cart. Both the power strip and overbridge instructions must be used.
2. On the rear of the power strip, place #6-32 x 1/2 screws in cross-slots. Insert screws into
the holes on the cord wrap’s long plate. Secure with (2) #6-32 nuts. Power strip is now
anchored to the cord wrap.
3. Determine which rear corner the power strip/ cord wrap is to be located. On the matching
overbridge support leg, align holes in cord wrap and support leg. Distance will be 21”.
4. Take the (2) #8-32 x 2” screws (supplied in the power strip hardware bag) and insert them
through cord wrap and overbridge leg. As detailed in the overbridge instructions, place
spacers and cam nuts on to #8-32x 2” screws. Do not tighten. Assemble the screws,
spacers and cam nuts (supplied with overbridge) into the other overbridge support leg.
5. Place the overbridge/ power strip against the rear of the cart, Aligning cam nuts with
cutouts in filler strips. Insert cam nuts into the post slots and tighten. Make sure cam nuts
lock into the post slot. Loop cord around wrap.
New #8-32 x 2” Screws in
Power Strip Hardware bag
X 2
Cord Wrap
Cam Nut
X
2/ Side
Raise circle on nut to
face towards screw
X2
X 2
Power Strip
Plastic Post
Filler Strip
Cut outs for
cam nuts
Rear of Starsys
21”
o
o
Overbridge
Support
Spacer
X 2 / Side
Power Strip / Cord Wrap
Mounted on Overbridge
INSTALLATION
INSTRUCTIONS

PART # SX595
Assembly consists of (1) Hospital Grade, 6 outlet, 15-ft Power Strip, (1) Cord Wrap,
(2) Hardware Bag
1. On the rear of the power strip place (2) #6-32 x 3/8 screws into the keyhole slots, trapping the heads in the
slots.
2. Place power strip against the long plate on the cord wrap inserting the screws through the mounting holes.
Secure with (2) #6-32 nuts.
3. In the holes on the cord wrap short plates, insert (2) #8-32x ¼ screws and start (2) cam nuts onto screws. The
raised circle on the cam nuts must face toward the screw. Leave loose.
4. The power strip/ cord wrap assembly can be mounted on either rear corner of the Starsys unit, however, one
corner will have the post filler strip removed at the factory for mounting. Determine the mounting height
location on the post and mark the cut locations on the filler strip. Two (2) 1” long sections must be cut out of
the filler strip in order for the cam nuts to be inserted into the post slot per the illustration below. Use a sharp
utility knife to score the sections, then snap them in half.
5. Insert cam nuts into the post slots and tighten. Make sure cam nuts lock into the post slot.
6. Insert the post filler strip sections into the post slot by pressing firmly and snapping them into place.
7. Loop cord around wrap.
Power Strip / Cord Wrap INSTALLATION
INSTRUCTIONS
X 2
Cord Wrap
Cam Nut
Raise circle on nut to
face towards screw
X 2
X 2
X 2
Power Strip
Plastic Post
Filler Strip
Cut outs for
cam nuts
Rear of Starsys
21”
INST-SX595
Rev. 4/04