MEXDA WS-0503 User manual
Massage Bathtub
Model：WS-0503
Install Manual
No advanced advice will be submit before we change our design and size.
The pictures may be a little different from the real products.
Our company keep the final explanation right.
Attention
1. Turn on the power and make sure it won't surpass the electric current.
2. Make sure to fix leakage protection device, and the socket must be
connected with earth line.
3. Please don't block the water recycle nozzle by any part of your body, if
that occurs, turn off the pump or power at once
4. A switch for the supply of the hot /cool water must be installed,when stop
to use this product the water supply switch and the power source switch
should be turned off.
5. Check the water level if it is 10-20mm above the spray nozzle before you
start the pump or the pump could be damaged.
6. Don't use corrosive detergent to clean the bathtub, you could use
common daily detergent or toothpaste to clean it.
7. Dispose of the product according to the local law when it is out of use.
8. Please contact the local dealer for help if you have any problem.
Do not dispose this product as unsorted municipal
waste. Collection of such waste separately for special
treatment is necessary.
1.
2. Connect the drainpipe to the cloaca.
3. Fix shower head and pillow.
4. Connect to the cool(blue) and hot(red) water pipe.
5. Connect to power source, then fill water to have a test.
Voltage: 220V-240V 50Hz /60Hz
Power: 1HP
Hydraulic pressure : 0.1～0.2Mpa
Size: 1500x1500x680mm/1800x1800x680mm
1. Fill water
Turn the cool/hot switch to adjust the water temperature, turn the
shift switch to fill water through shower head or faucet or waterfall.
Stop to fill water when the water level is 10-20mm above the water
jet.
2. Hydraulic massage
Press the pump switch to start the pump and bubble pump,then there
will be bubble come out from the air bubble jets and turn the air
regulator to adjust the hydraulic power. Push the jet to change the
water spray direction. Press the switch again to turn off the pump.
3. Shower
Turn the cool/hot water switch to get suitable temperature, then turn
the shift switch to use shower head to take a shower.
4. Power off
Press the pump switch to turn off the pump, then turn the drain
switch to let out the water,when stop use ,turn off the power source
switch and the water supply switch.
Adjust the feet-screw to make the bathtub horizontal.
Parameter
Operation
Installation
150
450
450
1 5 00
650
500
500
cold water
hot water
tap
shower
drainage
6
1500
930
1
2345
7
8
9
10
12
11
13
1.tap
2.cold water switch
3.shift witch
4
s
5.s
6.b
10.water inlet
.
.hot water switch
hower
ig nozzle
7.pillow
8.small nozzle
9.drainage
11 drainage switch
12.water pump switch
13.air conditioning
wood panel
board panel
Sketch
