Kohler Memoirs K-723-H2 User manual

Features
•Cast iron with Safeguard
®
finish
•Left or right drain
•ADA compliant when installed per Section 607 of the
Act
•Less all trim
•Variable-speed pump with 1.5 kW heater, back-lit
user keypad, and remote control
•6 FlexjetsTM
•60″(1524 mm) x 33-3/4″(857 mm) x 17-7/16″
(443 mm)
Codes/Standards Applicable
Specified model meets or exceeds the following:
•ASME A112.19.1/CSA B45.2
•ASME A112.19.7
•CSA B45.10
•CSA C22.2 No 218.2
•UL 1795
•ADA
•ICC/ANSI A117.1
5’ BATH WHIRLPOOL
K-723-H2
ALSO K-724-H2
Colors/Finishes
•0: White
•Other: Refer to Price Book for additional colors/finishes
Accessories
•CP: Polished Chrome
•PB: Vibrant
®
Polished Brass
•Other: Refer to Price Book for additional colors/finishes
Specified Model
Model Description Colors/Finishes
K-723-H2 5’ bath whirlpool – left drain ❑0❑Other_____
K-724-H2 5’ bath whirlpool – right drain ❑0❑Other_____
Required Accessories
K-9696 Jet trim kit ❑CP ❑PB ❑Other_____
Recommended Accessories
K-7161-AF Clearflo pop-up bath drain ❑CP ❑PB ❑Other_____
Optional Accessories
K-1491 Pillow ❑0❑Other_____
K-1601 Footstop ❑0❑Other_____
Product Specification
The bath whirlpool shall be 60″(1524 mm) in length, 33-3/4″(857 mm) in width, and 17-7/16″(443 mm) in height. Bath whirlpool
shall be made of cast iron with Safeguard finish. Bath whirlpool shall have 6 Flexjets, a variable speed pump with 1.5 kW heater,
and back-lit user control. Bath whirlpool shall be less all trim. Bath whirlpool shall be ADA compliant when installed per Section
607 of the Act. Bath whirlpool shall be Kohler Model K-_______-_______-_______.
MEMOIRS
®
Page 1 of 2
1019707-4-E
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
www.kohler.com

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 45” (1143 mm) x 23” (584 mm)
Basin area, top 54” (1372 mm) x 25” (635 mm)
Weight 390 lbs (176.9 kg)
To overflow:
Water depth 11-5/8” (295 mm)
Capacity 52 gal (196.8 L)
* Approximate measurements for comparison only.
Pump kW V A*
1.5 240 11
* Approximate measurements for comparison only.
Minimum access panel (required):
Pump/control 30″(762 mm) W x 15″(381 mm) H
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
NOTE: Pump protrusion beyond rim.
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
61 lbs/square foot (295 kg/square meter) loading.
17-7/16"
(443 mm)
8-1/2"
(216 mm)
3-1/4"
(83 mm)
1-1/2"
(38 mm)
32"
(813 mm)
16"
(406 mm)
60" (1524 mm)
2-7/8" (73 mm)
3" (76 mm)
33-3/4" (857 mm)
1-1/2" OD
1-13/16"
(46 mm)
1/8" (3 mm)
No change in measurements if connected
with drain illustrated. (K-7161-AF or K-7161M-AF)
Pump Protrudes Beyond Rim
1" (25 mm)
Pump/Control Access
Product Diagram
MEMOIRS
®
MEMOIRS
®
5’ BATH WHIRLPOOL
Page2of2
1019707-4-E