Micron SDR116 Instruction manual

Explorer 100 Series –SDR116 –SMALL DIVERSITY RECEIVER -Quick User Guide
Battery Status Indicator
Tri-colour 4-pin Hirose Audio Output Connector
Variable Audio Output
Line Level: 0dBV pot @max.
Mic Level: -42dBV pot @min.
RXA ‘Active’
Signal Status Indicator
Green
RXB ‘Active’
Signal Status Indicator
Green
‘A’ Side Antenna
Input Socket
‘B’ Side Antenna
Input Socket
(1) Connect provided RX
antenna
(semi-rigid straight & right-
angled
screw-on SMA antennas)
Setting Up Procedure:
The battery compartment is opened
by pressing the button on the back
of the unit. There is a slot for the 9V
battery to fit into.
(2) Fit a PP3 9V battery, check
RX battery status LED
Please watch polarity of
battery.
The battery can easily be
released with the aid of the
thumb. Battery Life approx. 5
hours
ON/OFF
Switch
(3) Connect Audio output cable and
switch on.
If the battery status LED is AMBER
replace RX battery
(to remove the audio output cable pull
outer shell)
(4) Set the receiver to the required
operating frequency
(5) Interference Check
•Switch off TX
•Observe RX ‘Active’ signal strength indicators and listen for possible
interfering signals from other transmitters. If there is very strong
interference then change the frequency until you find a clean channel.
(6) Set the required audio output level to match input requirements of
your system.

Explorer 100 Series –TX716A –POCKET TRANSMITTER -Quick User Guide
The battery compartment is opened
by pressing the button on the back
of the unit. There is a slot for the 9V
battery to fit into.
(2) Fit a PP3 9V battery, check
RX battery status LED
Please watch polarity of
battery.
The battery can easily be
released with the aid of the
thumb. Battery Life approx. 6
hours
Modulation Level
Indicator Mic Level Control
Audio Input Socket
6-pin LEMO
Antenna Socket
Battery Status Indicator
(7) Adjust LEVEL gain control, while the performer speaks at
correct level so that AF Peak LED comes on all the time, then
set gain back by two notches
at which AF Peak LED flashes
occasionally.
(5) Check TX battery status LED, if
RED replace battery with a new one
Setting Up Procedure:
(1) Connect provided TX antenna
(Screw-on SMA antenna)
(3) Set your TX frequency same
as RX
please note: to change
frequency turn unit on/off
(6) Check RX ‘Active’ Received Signal
Strength Indicators –a LED should be
GREEN
(8) NOW YOUR SYSTEM IS READY TO USE.
(4) Switch on TX
(by connecting microphone
cable to 6-pin LEMO socket)