5
CAUTIONS
BEFORE USE
The electronic levels are supplied in ABS
anti-shock boxes.
Inside each box you can find a complete
set of components, needed for the proper
operation of the level (see the component
list for each model).
Herewith are a few suggestions for the
maintenance and proper use of your in-
strument:
Before measuring, clean thoroughly the
surface to be checked and the base of the
level with specific detergents (Paste for
granite, Art. TZ0510 – Liquid detergent,
Art. DT0520). Never use wax, grease or
water-based detergents for cleaning gra-
nite.
Never use the instrument close to magne-
tic fields, as the measurements could be
altered.
The surface plate to be checked should
be levelled as closely as possible to avoid
inaccuracies of the readings due to com-
pound errors.
Check the levelling of the plate or the sur-
face to be measured by using a spirit level
following the instructions supplied with
the Microplan plates (Test report).
Before starting the measurement, check
the battery charge, pushing the button
‘Batt’ (VA110), or just checking that the
display does not show ‘Low Bat’ (VD110
and LE051).
Check the instrument periodically, to
verify its calibration and performance. A
periodical check of the instrument can
ensure better performance and lower
maintenance costs over time.
Lato Etichetta
Label Side
L
0.22 L0.22 L
0.22W0.22W
0.5 W
0.5 W
WVista Inferiore
Bottom view
