Microtips Technology Omago SG-101 User manual

User Manual for Omago Intelligent Diaper Sensor(SG-101/SD-101)
Thank you for purchasing Omago Intelligent Diaper Sensor. Please read this User
Manual detail before starting to use Omago Intelligent Diaper Sensor and following the
instruction.
Package contents
1) Omago Intelligent Diaper Sensor
2) Strap
3) User Manual
Omago Intelligent Diaper Sensor
Strap User manual
Product introduction
Getting Started
Please charge Omago Intelligent Diaper sensor battery fully before starting to use.
Installation
1. Put Intelligent Diaper Sensor (SG-101) on flat surface for sleep posture calibration and
press sensor button for 3~5 seconds for connection to Gateway. If connection
successfully. If not, please repeat above process. Please be noted, must put the
sensor on a flat surface for calibration accuracy. If not calibrating accurately, it may
affect sleep posture accuracy. The sleep posture detection function is for assisting
to parents and for information only. Parents still has to look after the baby all the
time.

2. Pressing the Dock link button, the button led will flash blue. Take one Intelligent
Diaper Sensor (SD-101)and press the connection button for 3-5 seconds for pairing.
The Dock link button led will become constant blue if pairing successfully. If not,
please repeat the link process.
3. If the sensor (SG-101) is out of the Gateway connection, the sensor led will blink red.
When it comes back to the distance range of the Gateway, it will re-connect to the
Gateway automatically.
4. If the sensor (SD-101) is out of the Dock connection, the sensor led will blink red.
When it comes back to the distance range of the Dock connection, it will re-connect
to the Dock automatically.
Sensor led indication
Situation
Sensor led
Turn off sensor
Red light flash one time
Sensor pairing
red light flashing
Sensor out of connection range
red light flashing
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 0.5
centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at
least 0.5 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate this
equipment. (Example - use only shielded interface cables when connecting to computer or
peripheral devices).