Resolution Products RE205 User manual

RE205_Honeywell_Temp_Instructions Page 1 of 3 7 Mar 16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Wireless
Security
Solutions
RE205 Temp Range, Honeywell-Compatible
Features
• Freeze and/or Overheat warnings.
o Can be used as just Freeze, just Overheat or both simultaneously.
o Uni ue Loops for each function.
• Integrated Magnetic Reed Switch for triple-duty door/freeze/overheat.
(magnet not included)
• Cover tamper.
• Strong, reliable RF signal.
• 8-10 year battery life on CR123A battery.
• Low Battery indication.
Ke Instructions
• Battery “+” faces towards spring.
• Enrolling:
 Place Panel in Zone Programming mode.
 Zone Type = for example, 24-Hr. Aux.
 Input Type = Supervised RF Transmitter.
 When asked for serial number, press Tamper switch.
 Program the desired Loop number you want that zone to
monitor. Loop functions are:
• Loop 1: Overheat.
• Loop 2: Magnetic Reed. (magnet not included)
• Loop 3: Freeze.
• Loop 4: Tamper.
• Test temp alarm functions by putting in a freezer, or blowing a hair
dryer on sensor.
Operation
• Freeze (Loop 3)
Alarm: when room temperature drops below 45F.
• Overheat (Loop 1)
Alarm: when room temperature rises above 100F.
• Magnetic Reed (Loop 2)
Alarm: when a magnet is pulled away from sensor.
• Tamper (Loop 4)
When cover is opened.
• Supervisory: every hour.
RE205_Honeywell_Temp_Instructions Page 2 of 3 7 Mar 16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Specifications
Freeze Alarm Temp: 45F +/- 2F
Freeze Restore: when temp increases 4F from alarm
Overheat Alarm Temp: 100F +/- 2F
Overheat Restore: when temp decreases 4F from alarm
Mounting hardware: # 4 or #6 screws
Replacement Battery: CR123A 1550 mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal Picture
Temp Element
Loop 1 = Overheat
Loop 3 = Freeze
Loop 4 = Tamper
Loop 2 = Magnetic Re
ed
Switch

RE205_Honeywell_Temp_Instructions Page 3 of 3 7 Mar 16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Notices
“GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell
International Inc., and Tyco Safety Products Canada LTD, respectively.
Resolution Products, Inc. products will function with one of either GE, DSC or Honeywell
systems. However, no Resolution product is produced by, endorsed by, nor is officially
associated with GE, Honeywell or DSC. Resolution recommends verifying proper enrollment
and operation, per control panel installation instructions, at installation.
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could
void the user's authority to operate this equipment.
FCC ID: U5X RE201
IC Notice
This device complies with Industry Canada license exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A RE201