MicroTouch Solo User manual

Care and Maintenance
Distributed by: Wayne, NJ 07470
Made in China © 2017 Ideavillage
[email protected]
MTSOLO112918MW
Thank you for your purchase of
MicroTouch®Solo®
DRY USE ONLY
(See cleaning instructions inside)
CLEANING
The MicroTouch Solo blade is fragile – please handle with care.
• If hairs have accumulated on the guide or blade, simply blow them o, or gently sweep
with included brush.
• Do not rinse blade. Can cause damage.
TO REMOVE TRIMMING GUIDE
Place thumb on top of Trimming Guide
(Image 8) and push down to ip guide o
Blade Head (Image 9). Lift Trimming Guide
o head (Image 10).
BLADE REPLACEMENT
For optimal results, replace the blade every 3-4 months, or when it no
longer provides the desired results. Go to www.SoloReplacementHeads.com
for special replacement head oer.
• Remove any attachments.
• With cover on, gently push the blade release up and hold the blade
to prevent falling (Image 11).
• Hold the new blade by its sides and press onto handle. There will
be a “click” when the blade is secure.
• Remove cover prior to use.
NOTE: Be sure the stem found under the blade head is centered prior
to securing blade to unit. After replacement, if blade does not move
once turned on, remove the head, turn unit on briey and reinstall head.
• DRY USE ONLY
• Do not rinse. Only use brush to clean blade.
•Keep out of the reach of children.
• Do not place or drop in water or other liquid
while plugged in.
• Do not rinse or submerge into water or other
liquid.
• Unplug and remove power cord before
cleaning/using.
• Do not use trimmer while it is plugged in.
Warning
Image 11
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
• This unit contains a Lithium Ion battery.
Dispose of in accordance with all applicable
federal, state and local regulations.
• Do not dispose of in re.
• Do not use your MicroTouch Solo on sensitive
or irritated skin.
• Always check the unit before use. Do not use
if damaged, as personal injury may occur.
• Trimmer is not intended for use on the scalp or
genital area.
U.S. Patent No. D828,627 and International Patent(s) Pending
Image 9Image 8
Image 10
Place thumb here Press down
TRIM
SHAPE
EDGE
with
micro-precision!

NOTE: Prior to rst use, test the blade on a small area on your arm or leg. If sensitivity or
allergic reactions occur, discontinue use immediately.
NOTE: As with all trimmers/shavers, use caution around sensitive areas, such as ears, to
prevent nicks or cuts.
CHARGING / RECHARGING
• Make sure the unit is fully charged before use.
• Plug the small end of the Charging Cable into the
MicroTouch Solo and large plug into a USB Port.
(Image 1) Initial charging or recharging requires
approximately 4 hours.
• The Power Indicator LED will turn RED when
charging. (Image 2) The light will turn o when fully
charged.
NOTE: Do NOT operate unit while plugged in.
• The MicroTouch Solo has a cordless operating time
of up to 45 minutes when fully charged.
NOTE: If unit begins to slow down, charge the
battery.
Features
Getting Started
How to Use
Blade
Image 2
Image 1
Blade
Release
Built-in
LED
Charging
Port
Battery
Charger
Adapter
USB Power
Supply
3 Trimming Guides
5mm 3mm 1mm
Power
Button
Power
Indicator LED
Charging
Cable
Brush
IMPORTANT: DO NOT RINSE BLADE.
CAN CAUSE DAMAGE. USE CLEANING BRUSH.
Blade Cover
The MicroTouch Solo is perfect for facial hair including beards,
goatees, mustaches, and sideburns. It is not intended for use on
the scalp or genital areas.
• The MicroTouch Solo is designed for DRY USE ONLY. Do not use
in shower or run blades under water.
• If blade cover is on, slide cover o prior to use (Image 3). Use
power button to turn MicroTouch Solo ON and OFF (Image 4).
NOTE: When the power is ON the Power Indicator LED light will
turn blue. It is recommended to keep the blade cover on when
not in use.
GROOM
Great for grooming body and facial hair.
• Control exact shape and length with the 5mm, 3mm, or 1mm
snap on guide (see below under “Trim”).
• Shave up or down with the dual-sided German stainless steel
blade to remove unwanted hair in seconds.
• Pivoting head contours prefectly to the body.
• LED lights hard to see areas.
TRIM
Choose a 5mm, 3mm, or 1mm guide to trim your beard to the
exact length you want or keep stubble exactly as you want it
(Image 5). (See back cover To Remove Trimming Guide).
• Make sure unit is o. Select one of the guides provided and place
it on the blade, ensuring both sides snap into place (Image 6).
Teeth can face both directions, depending on area being shaved
and most comfortable way to hold the unit.
• Do not move the unit too quickly. A smooth, gentle motion
is best.
• Always trim in the direction of the teeth of the guide, making
certain that the at part of the guide is in full contact with
the skin.
• For optimal results, try various trimming positions (upwards,
downwards, or across) and move the shaving head against
the grain.
• For best results, use when the skin and hair are fully dry.
NOTE: See back cover for Trimming Guide Removal Instructions.
SHAPE
The lighted pivoting head contours to your face and is designed
to give you complete control when shaping your beard (Image 7).
• DO NOT USE water and/or shaving cream. This can cause the
blade to stop working.
• Press lightly while making long strokes. Your skin may take a
while to adjust to the blade.
NOTE: It is normal for shaving head to become warm during use.
EDGE
Select the guide you prefer to give sideburns, mustaches, beards,
and goatees that barbershop perfect look. For more precise
trimming, use the unit without the guide.
• Use either edge of the blade for sharp lines.
• Hold the MicroTouch Solo unit with the blade to the skin,
with only one edge actually touching the skin (Image 8).
• Be sure to use smooth and gentle strokes.
Image 5
Image 6
Image 7
Image 4
Image 3
Power
Slide
SHAPES
EDGES
TRIMS
Image 8