Middle Atlantic Products RackLink User manual

I-00470 Rev -
RackLink
In-Line Models
MOUNTING INSTRUCTIONS
1) Loosen the thumb-screw until it becomes disengaged from the RackLink
unit (1). DO NOT fully remove the thumb-screw. The retainer washer
will hold the thumb-screw in place. Remove the RackLink
unit from the mounting bracket (2). (FIGURE A)
2) Install a screw into an oval nut as shown. Once tightened, insert the
oval nut into the slot in the rackrail bracket. Slide into the desired
location. (FIGURE B)
INSTALLATION
RACKRAIL
SLOT
™
PARTS LIST CALLOUTS
PARTS LIST QTY
A - RackLink Unit 1
B - Mounting Bracket with Factory Installed Thumb-Screw
and Integrated Retainer Washer
C - Oval Nut 2
D - #3 Phillips Head Screw 2
(FIGURE A)
(FIGURE B)
1
2
1
A B C
D

Page 2
3) Install a screw and oval nut into the corresponding fixed hole on the
rackrail bracket. (FIGURE C)
4) Insert the flanges on the mounting bracket into the slots on the unit (3). Tighten the thumb-screw to secure the unit (4).
The in-line RackLink unit can be installed with the receptacles facing out (FIGURE D) or to the side (FIGURE E).
INSTALLATION CONTINUED
(FIGURE C)
4
3
4
3
(FIGURE D) (FIGURE E)