Miele TX2349 User manual

Quick Start Guide
for dishwasher
These short instructions are not a substitute
for the Operating instructions supplied with the appliance!
Please read the Operating instructions supplied with
your dishwasher before using it for the first time and
take note of the Warning and Safety instructions as well
as the full descriptions on how to use your machine. M.-Nr. 09 523 280
en-AU

aProgramme selection
bTime display
cCheck/Refill indicators
dStart/Stop button with indicator light
aSalt reservoir
bFilter combination
eDelay start button with indicator light
fTurbo button with indicator light
gProgramme selector button
hOn/Off button K
Control panel

AFilling the salt reservoir F
^Remove the lower basket and
unscrew the salt reservoir cap.
Water or saline solution will run out
of the reservoir when the cap is
removed. It should therefore only be
removed in order to refill the salt
reservoir.
,Inadvertently filling the salt
reservoir with cooking salt, rinse aid,
powder or liquid dishwasher
detergent will damage the water
softener unit.
^Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds approx.
2 kg of salt.
^Clean any excess salt from around
the reservoir opening and then screw
the cap on again firmly.
^Run the "Gentle 45 °C" programme
with the "Turbo" function immediately
(without any crockery in the
dishwasher) to remove any traces of
salt from the cabinet.
BAdding rinse aid (
^Press the button on the lid of the
rinse aid reservoir in the direction of
the arrow until the flap springs open.
^Add rinse aid only until it is visible in
the opening.
^Close the flap firmly. It should click
into place.
^Wipe up any spilled rinse aid. This
prevents over-foaming occurring
during the next programme.
CLoad the dishwasher
DAdding detergent 8
^Follow the dosage recommended by
the manufacturer on the packaging.
^Press the button on the lid of the
detergent compartment in the
direction of the arrow until the flap
springs open.
The flap is always open at the end of a
programme.
^Add the required amount of
detergent and close the flap.
Brief instructions

ESwitching on the dishwasher
^Close the door.
^Turn on the tap if it is turned off.
^Press the Kbutton.
FSelecting a programme
^Select the programme required with
the Programme selector button.
GSelecting Turbo (if required)
The Turbo button is used for selecting
the Turbo option.
The option selected is active on all
programmes until the setting is
changed.
^Press the Turbo button.
The Turbo indicator light will come on.
HActivating Delay start (if required)
^Set the time required using the Delay
start button.
IStarting the programme
^Press the Start/Stop button.
JEnd of the programme - switching
off the dishwasher
The "End" indicator light will come on at
the end of the programme.
^Switch the dishwasher off using the
On/Off button K.
The dishwasher will continue to use
electricity until it is switched off with
the On/Off button K.
,To prevent the risk of steam
damage to the worktop edging
above the dishwasher, it is
advisable to leave the door closed
until you are ready to unload the
crockery. Alternatively, you can
open the door fully until the crockery
is cool enough to unload. Do not
leave the door only partially open.
KUnloading the dishwasher
Dishes tend to break and chip more
easily when they are hot.
Allow the dishes to cool until they are
comfortable enough to handle before
unloading them.
Cancelling a programme
If a programme has already started and
you wish to cancel it, proceed as
follows:
^Press the Start/Stop button for at
least one second.
The programme will be cancelled.

Cleaning the filters
Collection of coarse soil may cause the
filters to clog. The level of soiling and
time it takes before the filters need
cleaning will vary depending on use.
Check the condition of the filters
regularly and clean them if necessary.
,This dishwasher must not be
used without all the filters in place.
Take care when you are fitting the
filter combination that it is secured in
position correctly. Otherwise coarse
soil could get into the circulation
system and cause a blockage.
^Switch the dishwasher off.
^Turn the handle anti-clockwise to
release the filter combination a.
^Take the filter combination out b,
remove any coarse particles and
rinse the filter well under running
water. Use a nylon brush if
necessary.
,Ensure that course soil doesn't
get into the circulation system and
cause a blockage.
To clean the inside of the filter, the flap
must be opened:
^Press the catches atogether in the
direction of the arrows as shown, and
open the filter b.
^Rinse all the filters under running
water.
^Then close the flap so that the catch
engages.
^Replace the filter combination so that
it lies flat in the base of the wash
cabinet.
^Then turn the handle clockwise until
both arrows point towards each
other. The filter combination is locked
in place.
Cleaning and care

Cleaning the spray arms
Particles of food can get stuck in the
spray arm jets and bearings. The spray
arms should therefore be inspected
and cleaned regularly (approx. every
4 - 6 months).
^Switch the dishwasher off.
Remove the spray arms as follows:
^Take out the cutlery tray (if your
dishwasher is fitted with one).
^Push the top spray arm upwards to
engage the inner ratchet. Then
unscrew the spray arm.
^Push the middle spray arms upwards
ato engage the ratchet. Then
unscrew the spray arm b.
^Remove the lower basket.
^Pull the lower spray arm firmly
upwards to remove it.
^Use a pointed object to push food
particles into the spray arm jets.
^Rinse thoroughly under running
water.
^Replace the spray arms and check
that they rotate freely.

Crockery Soiling Programme
Mixed,
everyday crockery,
including pots and pans
Fresh to dried-on soiling
Variable,
sensor controlled wash
Shortened cycle
Glasses and plastic
containers, sensitive to
high temperatures Fresh,
easily removed
food deposits
Low temperature for a
gentle wash
Mixed crockery
Normal,
lightly dried-on
soiling
Standard programme
values
Shortened cycle
Pots
pans,
everyday
porecelain and
cutlery
Water and
energy-saving cycle
Stubborn,
dried-on food
deposits containing starch
or protein1)
Maximum wash power
Shortened cycle
1) Food such as potatoes, rice, pasta, stews or bakes can leave starchy deposits on crockery.
Deposits containing protein can be left by food such as meat, fish, eggs or casseroles.
Programme chart

Programme Detergent
Compartment I 2) Compartment II 2)
Sensor wash –
25 ml
or
1 Tab
+ Turbo
Gentle 45 °C –
20 ml
or
1 Tab
Light soiling 50 °C –
25 ml
or
1 Tab 3)
+ Turbo
Energy save –
25 ml
or
1 Tab
Pot & pans 75 °C 10 ml
25 ml
or
1 Tab
+ Turbo
2) see "Detergent"
3) In some cases, tabs may not dissolve completely.
3313 / 01