Mightymast Leisure CLUB User manual

1
CLUB
TABLE FOOTBALL GAME
ASSEMBLY INSTRUCTIONS
Please keep for future reference
Adult Assembly Required
(0316)

2
ASSEMBLY INSTRUCTIONS
Please keep these instructions for future reference. Adult assembly required.
This table is not a toy & is intended for use by or under the supervision of adults.
Please do not sit, climb or lean on the table.
This table is intended for indoor use only.
Parts Identifier
1. Find a clean & level place to begin the assembly of your CLUB table football game. You will
need a Phillips screwdriver, a 13mm spanner & a hammer. Remove all parts from the box &
save all packing materials until the parts have been inspected & the table is assembled.
2. Attaching the legs – place the table onto the floor facing the correct way up & then stand it
upright on one of the ends. Important – this should be carried out by 2 adults. If easier, turn
the table upside down onto the floor.
3. Fix the legs into the slots underneath the table using the bolts & nuts provided. Screw the 4
height adjusters to the bottom of each of the legs.
Insert the coach bolts into the sides of the table followed by a nut. The square neck of the bolt
will not fit into the round hole. Tighten the nut so that the neck breaks into the laminate but
do not over-tighten – this will not cause the laminate to crack. The mushroom head of the bolt
should just touch the laminate surface.

3
4. Stand the table up on its legs & prepare to fit the poles. Push the bars into the table, pushing
the handle-end of the pole through the hole first from the inside. Do not fit the handles onto
the poles at this stage.
Then starting from the blue score counters end of the table insert the poles as follows:
-Blue 1-man pole
-Blue 2-man pole
-Red 3-man pole
-Blue 5-man pole
-Red 5-man pole
-Blue 3-man pole
-Red 2-man pole
-Red 1-man pole
There should now be 4 poles on each side of the table with the blue & red teams facing each
other.
5. Now fit the pole bearings as shown in the diagram below. At both ends of the poles fit 2 half
moon bearings with legs to the inside of the table & then 2 half moon bearings without legs
to the outside of the table. Secure with 2 screws. Finally hammer on the handles to the end
of the poles.

4
6. If not already fitted, attach the 2 black plastic top ends to the top of the table with the 12
screws provided. The blue & red score cubes can then be screwed into these top ends with
the 4 long screws provided.
You are now ready to play
Cleaning & Maintenance
Use everyday household glass cleaner for both the glass & the laminate surface.
Mightymast Leisure is the UK & Ireland agent for FAS Italian table football games
For sales & service contact:
Mightymast Leisure Ltd, 58 Bentwaters Park, Rendlesham, Woodbridge, Suffolk. IP12 2TW.UK
Tel: [phone]
www.mightymast.com
[e-mail]