milliard GOLF ORGANIZER User manual

STOP : Please read the following
instructions entirely before attempting to
assemble or use the organizer for the first
time. Failure to follow assembly instructions
may lead to damage or injury.
WARNING:
• This product is for golf equipment only
• Do not use a partially-assembled organizer
• Not intended for commercial use
• Do not exceed total weight capacity of 150lbs
• Do not use organizer if damaged
• Perform assembly on a flat, level surface
If any parts are missing or defective contact us at [email protected] or call 866.686.4891
STOP
!
!
GOLF ORGANIZER
Congratulations on the purchase of your new Milliard™ Golf Organizer! With so many
accessories available to drive your drivers and perform the perfect putt, this handy rack
will keep all of your golf equipment in one place, neatly ordered and ready to hit the greens.
Golf Organizer
ASSEMBLY
5Position the foam tape-side of the upper back panel (3)
facing the inside of the assembly as shown and secure
it to the left, center, and right-side panels with three
long screws and nuts.
6
Insert the bottom (8), middle (7),
and top (6) shelves by placing
them on the corresponding shelf
brackets provided on the middle
and right side panels. Place the
notched side of each shelf toward
the back for proper installation.
7Attach the top shelf face (9) to the
middle panel and the right panel
by using three long screws and
nuts.
8
Lay the assembly on its back and attach the front brace
(11) to the side panels with short screws (15) and nuts
(13) just above the bottom panel as shown.
Attach the four foot pads (14) at each of the bottom
corners, and then stand the assembly upright.
FRONT BASE
FOOT PADS
BOTTOM SHELF
MIDDLE SHELF
TOP SHELF
TOP SHELF FACE
UPPER BACK PANEL
FOAM TAPE LOCATION
Milliard Brands © 2017 All Rights Reserved.

Golf Organizer
PARTS
Golf Organizer
ASSEMBLY
Left Panel
1
Top Shelf
6
Front Brace
11
Lower Back Panel
2
Middle Shelf
7
Long Screws (X17)
12
Upper Back Panel
3
Bottom Shelf
8
Nuts (X20)
13
Middle Panel
4
Right Panel
5
Top Shelf Face
9
Bottom Panel
10
Foot Pads (X4)
14
Short Screws (X3)
15
1
Bring the carton and its contents near the area where
the organizer will be used and check that all the
pieces listed on the parts list are present. Place the
bottom panel (10) so that the mesh side is on top, and
then position the lower back panel (2) so it is facing
forward toward the bottom panel as shown. Secure
them together with long screws (12) and nuts (13).
2Position the left panel (1) with its foam side facing in
toward the rest of the assembly and secure it to the
base and the lower back panel with three long screws
(12) and nuts (13).
3
Position the middle panel (4)
toward the center-right of the
assembly with its foam tape
facing the left panel. Secure it to
the base and the lower back panel
with two long screws (12) and
nuts (13) as shown.
4
Position the right panel (5) on
the right side of the assembly as
shown, and secure it to the base
and the lower back panel with
three long screws and nuts.
MESH ON TOP
LOWER BACK PANEL
BOTTOM PANEL
Milliard Brands © 2017 All Rights Reserved.
LEFT PANEL
LEFT PANEL
MIDDLE PANEL
RIGHT PANEL
FOAM TAPE LOCATION
FOAM TAPE LOCATION