Minicraft Models USAF F-15A User manual

1 2
5
4
14693
Cement Do Not Cement Symmetrical L/ROptional
Your MINICRAFT F15A includes optional parts for a 'stationary' or 'ground' version with extended landing gear, or 'in-flight' versions. Optional armament of Sparrow
missiles are provided, as well as optional drop tanks. Please review the assembly steps to become familiar with the parts before beginning assembly.
PARTS LAYOUT DIAGRAM
3IN-FLIGHT VERSION
STATIONARY VERSION
BOTH VERSIONS
(Stationary version ONLY)
Add noseweight
Exhausts BURNT METAL
Cockpit interior DARK GRAY
2
1
4
3
11
18
18
12
5
6
10
10
13
16
17
16
13
8
7
9
17
14
14
15
15 (Shown in place)
Canopy
Missiles WHITE
Drop tank LIGHT GRAY
Struts/hubs/wheel well and door interiors WHITE
Tires FLAT BLACK-GRAY
Note alignment angle
NOTE
Missile and drop tank installation
is same for in-flight
or stationary versions.
NOTE
Missiles 10 shown in place
on starboard (right) side
Cut
3
4
6 5
987
10
(4x)
2
1
18 18
17 16
15
14
13
12
11
Canopy

USAF F-15A, Prototype, USAF St. Louis, MO, 1982
14693
PAINTS
A White (ModelMaster 1745, Acryl 4696)
B Blue FS15052 (ModelMaster 2727, Acryl 4661)
C Jet Exhaust (ModelMaster 1796, Acryl 4676)
D FS36320 Dark Ghost Gray (ModelMaster 1741, Acryl 4761)
E FS36375 Light Ghost Gray (ModelMaster 1728, Acryl 4762)

USAF F-15A, Bitburg AB, Germany, 1977
14693

Your Minicraft model includes high-quality waterslide decals. These decals adhere best
to a glossy surface; and it is recommended that you apply a clear gloss coat over your
painted model.
Use a sharp scissors or knife to cut individual decals from the carrier sheet. Do not cut
into the clear film surrounding the individual decals.
* It is recommended that you apply one decal at a time.
* Place the decal section in warm water, when first inserted in the water your decal will
curl, after approximately ten seconds the decal will uncurl. Remove from water and lay
on a paper towel. After approximately 10 - 20 seconds the decal will slide freely from the
backing paper. Use a small brush to help slide the decal from the backing paper and into
position on the model. Carefully blot excess water from the decal, using care not to move
the decal or tear it.
* If you choose to use a setting solution, apply a thin coat over the decal following the
manufacturer’s instruction.
* Allow the decal to dry overnight. Wash any adhesive residue off the model with a small
amount of clean water and dry thoroughly.
* Apply clear gloss, matte or flat coat to seal decals following the instructions from the
manufacturer.
Visit our Website-
www.minicraftmodels.com
Minicraft Models (US) LLC
1501 Commerce Drive
Elgin, IL 60123
Phone: [phone]
Printed in China