minipcr P51 User manual

Setup Guide
Patent pending

Box contents
You will also need:
A 9V battery
A Phillips screwdriver
Yellow filter
Battery case
LED strip
Insert
Viewer
-1-

2. Fold flap down into
the viewer.
Viewer
1. Unflatten box.
4. Fold back flap into the
viewer.
Push hard!
5. This is how the viewer base
should look now.
6. Fold cover flaps. 7. Close viewer (Velcros hold
lid closed).
Almost there...
-2-
1
3. Fold side flaps down and interlock them with .
12
3

View from the
bottom.
1. Fold up at crease .
2. Fold up at crease and Insert TAB A into SLOT A.
Insert
3. Peel off the protective layer on
back of LED to expose the
adhesive strip.
-3-

Make sure that the cables exit as indicated.
Make sure cables stick out
through the slot.
6. Fold the side flaps, engage them at point B, and interlock.
Repeat on the opposite side with point C.
4. Stick the LED onto the light grey surface marked “LED”,
making sure the cables exit as indicated.
5. Fold the Insert across and ,
about 90 degrees each.
-4-
B

Getting there!
Battery pack
1. Use screwdriver to open battery pack
and insert 9V battery.
2. Peel backing off the Velcro to
expose the adhesive.
3. Adhere battery pack to back
corner of Insert.
-5-
Make sure to
align the corner
of battery pack
with corner of
Insert.

1. Connect battery wires to LED.
Putting P51 together
3. Insert yellow filter against the front
window.
2. Peel yellow filter protective films
from both sides.
4. Place Insert in the box with its window facing
the filter. The fit is tight, so some pressure is
needed.
-6-
Tip:
Tilt viewer down so that
the filter stays in place
when adding the Insert

5. Make sure you can reach the power switch
from the opening in the back.
Ready to explore!!!
-7-
© Amplyus, LLC