MistAway iMist2 User manual

iMist2 Setup Guide – Part 1
Connect Gateway to Internet
•Locate the modem or router that provides an internet connection to
customer’s property.
•Thread antenna (yellow stripes) onto coax connector on gateway.
•Connect gateway to router with Ethernet cable.
•Connect gateway to power with adapter. Orient connector as shown (ridges
on top) and gently push the connector into power port.
•ndications: Red – Power, Blue – nternet on, Green – connection with iMist.
•All three lights will come on. After 3 secs, green and blue lights will go off. n
about two minutes, after gateway completes bootup and downloads any
firmware updates, green and blue lights should come on and stay on.
Add Customer
from App
•Full – website and
dealer app
•Mobile - customer
app only
Select Customers Add New Customer nput Customer nfo Save Customer
Add Customer and Associate Gateway
Associate
Gateway with
Customer
Select Gateways Add New Gateway Enter Customer and SelectConfirm nstructions
Adding Gateway
Enter MAC and Select f Added, Pair or
Return to Gateways
f Unable to Add, confirm
gateway lights and try again
f retrofitting iMist2-ready remote hardware, see mistaway.com/25550 for instructions.

iMist2 Setup Guide – Part 2
Pair Misting Unit with Gateway (at the misting unit
Select Gateway
to Pair
Select Gateways Select Customer and Pair
Put Node on Misting Unit into Pairing Mode
•DATA menu, UP arrow, select LGW. Press and hold
Green/Arrow button for 3 seconds.
•GWL ON and countdown starts.
Pair Gateway
and Node
Pairing countdown
App confirm Gateway
Connection. Press Pair
Misting Units
Confirm nstructions and
press Begin Pairing
“DONE” indicates
successful pair
Name the misting system
and respond to prompt
f finished, check connection
between gateway and node
Wait while data
synchs
3 – 5 minutes
Send login invitation to
your customer from
Customer Manager
f pair fails, follow these
instructions and retry
Sync Data
Check Connection
Send Invitation