MOBB Health Care Alternating Pressure Mattress User manual

If you have a question about your MOBB Healthcare
device or this warranty, please contact an authorized
MOBB Healthcare dealer.
MOBB Healthcare warrants to the original consumer
purchaser for as long as they own their MOBB
product that it will be free from defects in material
and workmanship under normal use. This warranty
is only applicable to products used in residential
applications within the United States and Canada
and is not transferable to subsequent owners.
Should defects in material or workmanship exist
during the applicable warranty period in any MOBB
Healthcare Product, MOBB Healthcare will elect at
its discretion to either repair or replace the defective
material. This warranty covers only parts and
materials of the products supplied by MOBB
Healthcare. Not covered under this warranty are
wear and tear items or abuse of the product in a
manner that was not intended for the product to be
used. This warranty shall become void if the product
is in any way modified, improperly adjusted or
abused.
Lifetime Limited Warranty
MOBB Healthcare Lt d .
116A Viceroy Rd. Unit 5-6
Concord, Ontario, Canada
L4K 2M1
www.mobbhhc.com
MHAM102
Alternating Pressure Mattress
140 kg / 309 lbs

Brief
The Alternating Pressure Mattress consists of
two parts: the mattress and the pump. The pump
utilizes a small compressor to remain quiet and
energy efficient. The control panel is simple and very
user friendly. The mattress relieves pressure by
sequentially deflating and inflating alternate air cells
on approximately 12 minutes timed intervals. It is
widely recognized that constant pressure to a bony
prominence is the leading cause of skin breakdown.
The continuous movement supplied by the unit
lessens the areas of constant pressure and
enhances circulation.
Caution
1. Do not smoke on or near the pump.
2. Keep the pump away from heated surfaces.
3. Explosion risk if used in the presence of flammable
anesthetics.
4. Replace fuse as marked: T1A 250V.
5. Power Input: AC 110V 60Hz, 0.1A
10 lbs (2.3kg)
3 lbs (1.4 kg)
309 lbs (140 kg)
AC 110V 60Hz, 0.1A MAX
T1A 250V
10°C to 40°C (50°F to 104°F)
10% to 75%
-18°C to +43°C (0°F to 110°F)
10% to 95%
Alternating Pressure Mattress User Manual WEIGHT OF PRODUCT
MATTRESS WEIGHT:
PUMP WEIGHT:
WEIGHT CAPACITY
MAXIMUM PATIENT WEIGHT:
ELECTRICAL
OPERATING POWER:
FUSES:
ENVIRONMENTAL CONDITIONS
OPERATING CONDITIONS
Ambient Temperature:
Relative Humidity:
STORAGE AND SHIPPING CONDITIONS
Ambient Temperature:
Relative Humidity:
Circuit Diagram
Features
1. Place the mattress on the bed frame with the hose
end at the foot section of the bed frame.
2. Using the integrated hooks, securely hang the
pump on the bed end at the foot end or place on a
smooth flat surface.
3. Connect the air hoses from the mattress to the
pump.
4. Plug the pump into a wall outlet. Be sure the power
cord is safely away from possible hazards.
5. Turn on the power switch on the control panel of
the pump. The pump will begin to inflate the mattress.
6. After inflation, adjust the mattress using the dial on
the pump.
Operation