Brief
The BUBBLE MATTRESS consists of two parts: the
mattress and the pump. The pump utilizes a small
compressor to remain quiet and energy efficient. The
control panel is simple and very user friendly. The
mattress relieves pressure by sequentially deflating and
inflating alternate air cells on approximately 6 minutes
timed intervals. It is widely recognized that constant
pressure to a bony prominence is the leading cause of
skin breakdown. The continuous movement supplied by
the unit lessens the areas of constant pressure and
enhances circulation.
Operation
1. Place the mattress on the bed frame with the hose
end at the foot section of the bed frame.
2. Using the integrated hooks, securely hang the pump
on the bed end at the foot end or place on a smooth flat
surface.
3. Connect the air hoses from the mattress to the pump.
4. Plug the pump into a wall outlet. Be sure the power
cord is safely away from possible hazards.
5. Turn on the power switch on the control panel of the
pump. The pump will begin to inflate the mattress.
6. After inflation, adjust the mattress using the dial on
the pump.
Caution
1. Do not smoke on or near the pump.
2. Keep the pump away from heated surfaces.
3. Explosion risk if used in the presence of flammable
anesthetics.
4. Replace fuse as marked: T1A 250V.
Power Input: AC 110V 60Hz, 0.1A
DIMENSIONS
0$775(66/HQJWK[:LGWK[+HLJKW
Extension Flaps
PUMP (Length x Width x Height):
WEIGHT OF PRODUCT
MATTRESS WEIGHT:
PUMP WEIGHT:
WEIGHT CAPACITY
MAXIMUM PATIENT WEIGHT:
ELECTRICAL
OPERATING POWER:
FUSES:
ENVIRONMENTAL CONDITIONS
OPERATING CONDITIONS
Ambient Temperature:
Relative Humidity:
STORAGE AND SHIPPING CONDITIONS
Ambient Temperature:
Relative Humidity:
77″×35″×3″
(195cm×88cm×7.5cm)
20″(50cm) For both sides
10″×5″×4″ (26cm×13cm×10cm)
5 lbs (2.3kg)
3 lbs (1.4 kg)
300 lbs (136 kg)
AC 110V 60Hz, 0.1A MAX
T1A 250V
10°C to 40°C (50°F to 104°F)
10% to 75%
-18°C to +43°C (0°F to 110°F)
10% to 95%
