Mobi Technologies Cube Speaker User manual

!
!
MOBI Cube Speaker Instructions
Thank you for purchasing this Mobi product. To maximize your satisfaction please become familiarized
with this entire document. Enjoy!
Note: Your Mobi Cube Speaker needs to be fully charged before use.
Charging Instructions
The MOBI Cube Speaker should be fully charged for 4 hours before use. Plug the included micro USB
cord into the ‘5V IN’ port on the bottom of the speaker, and the other end into a USB AC adapter or USB
port on a PC. The unit will have a flashing red light on the top side to indicate unit is charging. The
flashing red light will turn green once the unit is fully charged and ready to use. The green light will turn
red once the battery level is at 20% or lower.
Note: The device can be used via Bluetooth or AUX mode while being charged.
Playing Music via Bluetooth Mode
1. To turn speaker on, press and hold the button for 1 second located on the bottom of the
unit. A green light will appear on the top side to indicate that the unit is on. A blue light will flash
indicating that it is searching for a Bluetooth connection.
2. While your Bluetooth enabled device is in search or scan mode, it should discover a new profile
called “MOBI Cube”. Select this profile to sync your device to the speaker.
3. It will then make a beep sound when it has successfully syncs to your device. If the device does not
sync, turn the Cube Speaker OFF for 30 seconds: turn it back ON and try again.
*If there was a previous unit linked with your device, it may be preventing the speaker from
pairing. If that is the case, please turn off your Bluetooth settings and try again.
Note: Only 1 Bluetooth device can connect to the speaker at a time.
*When the unit is left untouched with no Bluetooth, it will automatically shut off.
Playing Music via AUX Mode
1. Turn the speaker on by pressing the button located on the bottom of the unit. A green
light will appear on the top side to indicate that it is on.
2. Connect one end of the 3.5 mm audio cable to the AUX In port located on the bottom of the unit.
3. Connect the other end to your audio device.
Note: Connecting the audio cable will override Bluetooth mode. Speaker will automatically switch to AUX
mode when audio cable is connected.
LED “Light Show” Feature
1. To turn on the LED light show feature, press the button on the bottom of the unit.
2. Continue to press the button to cycle through the 5 different light show modes (6th press
turns the light mode off).

!
!
Note: The music sync enables when it is pressed a 5th time. It will go as high or low depending on the
volume of your music.
Safety
•Keep away from small children as some parts may become a choking hazard.
•Do not use close to ear as it may cause damage to hearing.
•Use only the attachments or accessories recommended or sold by the manufacturer.
•Never spill liquids of any kind on the product.
•Do not attempt to service this product yourself as opening or removing covers may expose you to
dangerous voltage or other hazards.
•This product should be situated away from heat sources such as radiators, heat registers, stoves,
or other products that produce heat.
Troubleshooting
1. Please make sure to Charge the product for 4 to 6 Hours before use.
2. Please insert or remove the Charger Carefully to avoid damaging the Unit.
3. If the sound is distorted: Try lowering the volume control of your sound source/Bluetooth device.
4. If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the
bass level. This will allow you to play the music louder before clipping (distortion) occurs.
Limited Warranty
Mobi® Technologies, Inc. warrants this product to be free from defects in material and workmanship for a
period of ninety (90) days from the date of purchase. Should this product prove to be defective at any time
during the warranty period, Mobi® Technologies, Inc. will, at its option, either replace or repair it without
charge. After the warranty period, a service charge will be applied for replacement of parts or labor for
repair. To obtain warranty service, please return the product to Mobi® along with a dated sales receipt
from the place of purchase. Purchaser is responsible for shipping the product to Mobi® Technologies, Inc.
at the address indicated below and for all associated freight and insurance costs. This warranty does not
cover damage caused by accident, misuse, abuse, improper maintenance, unauthorized modification, or
connection to an improper power supply. A charge will be made for repair of such damage. This warranty
excludes all incidental or consequential damages and any liability other than what is stated above.
Mobi Technologies, Inc.
8370 Wilshire Blvd. Suite 210
Beverly Hills, CA 90211
www.getmobi.com
Mobi is a trademark of Mobi Technologies, Inc.
© 2014 Mobi Technologies, Inc. All Rights Reserved