Modern Lights LumaNumbers User manual

LumaNumbers & LumaLetters come in a variety of sizes, colors and
mounting options.!They can be installed horizontally or vertically
directly to a buildings exterior or by using our mounting plates. !
Depending on the type of installation,
tools needed include a drill with
3/16th bit, a marker or pencil, a
leveler and/or tape measure, a hot air
gun or hair dryer, and a Phillips
screwdriver.
!
Carefully unbox each number and lay them out, being careful not to
scratch the finish on the numbers. We recommend placing the numbers
on a cloth of towel to prevent scratches during setup and pre-install.!

Each package includes standard mounting
hardware. Some surfaces may require
additional anchor bolts. 2 types of
mounting risers are included; ½inch and
¼inch.!The optional mounting plate also
includes 4 additional screws and plastic
caps to cover the screw holes for a clean
appearance once installed. The mounting
plates and caps come finished in off-white,
but can optionally be painted with the
color of your choice.!!
Each number includes mounting screws for
securing the numbers to the back of the
mounting plate and two threaded shafts if
you choose to install the numbers directly
to the wall.

To install directly into wall, level each template
against the surface and mark where to drill the
holes. If using the mounting plate, tape the
templates to the plate. The included screws are
designed to screw directly to the wall or into
anchor bolts depending on the type of wall.!
Using a 3/16th drill bit, drill holes into the wall or
mounting plate along the hole guides outlined on
the templates. Please use appropriate hand and
eye protection. There are two holes for the screws
and one to run the wiring through the wall or
mounting plate. Once completed, remove the
template guides.
If using the mounting plate, level and mark where
you wish to mount the plate and drill holes in the
desired location.

To install the numbers onto the mounting plate,
insert the two screws included with each number
through the back of the mounting plate for each
number.
Install the risers behind the numbers between the
wall or the mounting plate. The ½inch riser will
create a broader light spread as opposed to the ¼
inch riser, which will display a more narrow!light
spread behind each number. !
If installing directly into the wall, use the appropriate
anchors (not included). Screw the threaded shafts
into the numbers.
Next, run the wires through the drilled holes, being
careful not to damage or strip the wires as you feed
them though to the backside of the mounting plate.

From the backside of the mounting plate, gently
thread the screws into back of the numbers and
then tighten the screws into the back side of the
numbers. Do not over tighten, and use just
enough force to secure the numbers.
!
Cut each wire to desired length and strip the wire
covers so the wires can be twisted together.!Twist
two of the gray wires together and two of the
white wires together.!The gray and white wires
will be used to connect to the power source. !Use
the included wire splicers to join the twisted pairs.

Finally, use a heat gun or hair dryer to seal the
joined wiring to lock the connections together,
which solders the wires together at the same
time. The remaining single gray and white wires
will be used to connect to the 12v DC power
source.!The gray wires will connect to!+12v DC
and the white wires will connect to -12v DC. For
assistance, please contact a licensed electrician.
Secure the mounting plate to the wall using the
included screws. If your building exterior
material requires wall anchors, please source
and install these as they vary by material and are
not included.
Next, place the plastic caps on over the holes to
hide the screws and create nice clean
appearance.

If you have any
questions, please
visit our website.
ModernLights.com