Moducase DF30 User manual

DF version modular display case Model:
DF30 and DF60

20x
M5 Bolt
20x
Washer
20x
Sliding nut
2x
L- Bracket
1x
Allenkey set
1x
Safety hand
screw
2x
Spotlight LED
2x
Vertical stack
bracket
4x
Spotlight
screws
4x
Leg stands
Optional:
2x
Rubber slot
(transparent blue)

Back frame –No magnet
Front frame –With magnet

1. Back frame

2. Top panel (Inner side facing down)
3. Side panel
Tear off protection film
Flip unit, rest on the back. Tear off protection film

4. Slide in front frame
Top direction, with nut
Top direction
Top panel

5. Secure front frame
Enhanced display weight loading. If enhanced is not included in your display, please skip to step 7.
6. Enhancement installation
a. Insert and align sliding nut on front and back bottom frame to position and screw aluminium
bar in
Nut 4x

Align according to the “This position”
label
Front
Back
Insert at an angle and push in

b. Insert angle bracket and screw it at 4 corner
Front
Back
Insert at an angle and push in
Secure angle bracket with M5
black bolts

7. Insert 12x sliding nut.
8. Push sliding nut on back frame to position, according to the back panel’s hole. Screw on back
panel with 12x M5 screw. ( Inner side facing display)
Insert at an angle and push in

9. Flip the display to rest on the back
*Take note of the orientation of the display case
Top orientation,
with nut
Front
Back

10. Flip unit to rest on the bottom frame
Front
Back
Top orientation,
with nut

11. Insert bottom panel
12. Place front panel.

13. Insert slot rubber (Transparent blue rubber)
14. Screw in safety hand screw
Rubber slot
(Shaded grey)