modway EEI-2048 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI –2048/2873 DESK
Hardware:
Component:
ALong Bolt M6x30mm x2
DAllen Wrench x1
1 Desk Top x1 2Desk Leg x2
CFlat Washer M6 x10
Thank you for purchasing the MODWAY DESK！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the desk, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
2
1
2
BShort Bolt M6x16mm x8

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –2048 DESK
Ax2 Cx8 Dx1 Cx10
STEP 1:
Hardware & Tool required
STEP 2:
Assembly is completed. The desk is ready to enjoy now!
Please put the Desk Top (1) upside down on a carpeted or padded surface.
Attach one piece of Desk Leg (2) into the bottom of Desk Top (1) by using 1 piece of Long Bolt (A) and 4 pieces of
Short Bolt (B) and 5 pieces of Flat Washers (B) as shown.
Repeat the same step for the remaining Desk Leg (2).
Use Allen Wrench (C) to tighten the Bolts (A) clockwise until secure.
Carefully turn over the desk.
1
2
2
A
B A A
A
B
B
A
1
2
D
B
B B
B B
B B