modway EEI-2234 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI –2234/2235 CHAIR
Hardware:
Component:
C Flat Washer M8 x 8
1
Chair Back x1
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
2 Seat Frame x1 3 Front Leg x2
A
B Spring Washer M8 x 8
D Allen Wrench x 1
2
3
1
3
Bolt M8x50mm x 8

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –2234/2235 CHAIR
STEP 1:
STEP 2:
2
Ax4 Bx4 Cx4 Hardware & Tool required
A C
B
Ax4 Cx4 Bx4 Hardware & Tool required
1
3
C
B
A
1
Please put Chair Back (1) upside down on a carpeted or padded area.
Then open the Velcro on bottom of the Seat Frame (2), The inside of the Seat Frame(2) will now be visible.
Attach Seat Frame (2) to Chair Back(1) by using 4 pieces of Bolt (A), 4 pieces of Spring Washer (B) and 4 pieces of Flat
Washer (C) as shown.
Do not fully tighten Bolt (A) at this step.
Insert 1 piece of Front Leg (3) into the bottom of Seat Frame (2) as shown.
Attach by 2 pieces of Bolt (A), 2 pieces of Spring Washer (B) and 2 piece of Flat Washer (C) as shown.
Repeat the same steps for Front Leg (3).
Do not fully tighten Bolts (A) for either leg.
2
3

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI –2234/2235 CHAIR
STEP 3:
Assembly is completed. The chair is ready to use now!
Dx1 Hardware & Tool required
D
Carefully turn over the chair.
Please put a heavy object or seat one adult on top of the Seat Frame (2) to pressure the chair for leveling.
Fully tighten all Bolts (A) with Allen Wrench (D).
Recover the Velcro on bottom of Seat Frame (2).