modway EEI-2859 User manual

MM
Thank you for purchasing the MODWAY OFFICE CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components
and hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
1
Bolt M8*15
X4
2
Flat Washer
X4
3
Allen Wrench M6
X1
Component:
A Chair Body x1
E Cylinder x1
B Armrest x2
F Chair Base x1
CDecoration Cover x 1
G Castor x5
D Control Mechanism x1
Customer Service 908-368-1025︱www.modwayfurniture.com Page
1 of 3
E
EEI-2859
OFFICE CHAIR
A
C

STEP 1:
Please put Chair Base (F) upside down on a carpeted or padded surface.
Insert 1 piece of Castor (G) into the Chair Base (F) by hand as shown.
Repeat
the same steps for the remaining 4 pieces of Castors (G).
G
F
STEP 2:
Flip the assembled Chair Base (F) with Castors (G) on the floor.Insert the Decoration Cover (C) into the
assembled Chair Base(F) as shown.Insert the bottom end of Cylinder (E) into the assembled Chair Base (F)
as shown.
Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI-2859
C
OFFICE CHAIR
F

STEP 3:
Attach Control Mechanism (D) to the Chair Seat (C) by using 4 pieces of Bolts (1) with 4 pieces of Flat Washers
(2) as shown.
Tighten Bolts (1) by using Allen Wrench M6(3) as shown.
Bolt
(1)
Flat Wrench （ 2 ）
D
1*4pcs 2*4pcs 3*1pc
STEP 4:
Please insert the bottom holes of Control Mechanism (D) into the top end of Cylinder (E) and Chair Base (F) as
shown.
Assembly is completed .The office chair is ready to enjoy now!
Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
D
E
C
A
Allen W rench M6(3)
Hardware&Tool required
EEI-2859
OFFICE CHAIR
A
FG
G
G
G
B