modway EEI-4681 User manual

EEI-4681/ 4682/ 4683 CHAIR
Customer Service 609-256-9000︱www.modway.com Page 1of 3
Thank you for purchasing the MODWAY CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x20mm x2
Flat Washer x4
1.ChairBodyx12.BigLegx13.SmallLegx1
A.
E. Allen Wrench x1
D.
Spring Washer x4
C.
Bolt M6x25mm x4
B.

EEI-4681/ 4682/ 4683 CHAIR
Customer Service 609-256-9000︱www.modway.com Page 2of 3
STEP 1:
1. Insert Small Leg (3) to Big Leg (2) as shown.
2. Insert 2 pieces of Bolts (A) from the pre-drilled holes on the Small Leg (3) into the Big Leg (2) as shown.
3. Use Allen Wrench (E) to tighten Bolts (A) as shown. Do not fully tighten Bolts (A).
(Note: arrow is pointing front direction, the Big Leg is labeled with 2 and the Small Leg is labeled with 3 )
STEP 2:
1. Please put Chair Body (1) upside down on a carpeted or padded surface.
2. Put the assembled Big Leg (2) and Small Leg (3) on the Chair Body (1) as shown.
3. Insert 4 pieces of Bolts (B) with4piecesofSpring Washers (C) and 4 pieces of Flat Washers (D) from the
pre-drilled holes on the assembled Big Leg (2) and Small Leg (3) into the Chair Body (1) as shown.
4. Use Allen Wrench (E) to tighten Bolts (B) as shown. Do not fully tighten Bolts (B).
5. When all parts are fixed, please fully tighten all Bolts (A&B).
(Note: arrow is pointing front direction)

EEI-4681/ 4682/ 4683 CHAIR
Customer Service 609-256-9000︱www.modway.com Page 3of 3
STEP 3:
Carefully turn over the assembled chair.
Assembly is complete. Your chair is ready to enjoy now!