modway EEI-3718-NAT-TAU User manual

AScrew M7x90mm x 4
2. Leg Frame 2
3. Back
x1
EEI-3718-NAT-TAU CHAIR
Hardware:
Component:
Page 1 of 3
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Customer Service 609-256-9000 www.modway.com
1. Leg Frame 1 x1
12
3
44. Seat
B
5
5. Brace Rail
x1
x1
x1
6. Seat Cushion x1
6
Bx 4
Allen Wrench M5 x 2
D
Screw M7x70mm
Cx 2
Screw M7x60mm

Attach Legs frame 2 (2) to Seat (4) and Brace rail (5). Then insert 2 pieces of Screw (A) and 1 piece Screw (B) through
Legs frame 2 (2) into Seat (4) and Brace rail (5). Tighten using 2 pieces of Allen Wrench (D).
x2
A
EEI-3718-NAT-TAU CHAIR
Page 2 of 3
STEP 1:
Hardware & Tool required
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
STEP 2:
x2
D
B
x1
B
A
D
x2
A
x2
D
x1
B
D
B
D
A
A
D
A
2
4
5
1
4
5
Attach Legs frame 1 (1) to Seat (4) and Brace rail (5). Then insert 2 pieces of Screw (A) and 1 piece Screw (B) through
Legs frame 1 (1) into Seat (4) and Brace rail (5). Tighten using 2 pieces of Allen Wrench (D).

Carefully position the assembled chair to the desired location.
EEI-3718-NAT-TAU CHAIR
Page 3 of 3
STEP 3:
Hardware & Tool required
STEP 4:
Assembly is complete. Your chair is ready to be used now!
Customer Service 609-256-9000 www.modway.com
Attach Back (3) to the assembled Leg frame (1&2) and Seat (4). Then insert 1 piece of Screw (B) and 1 piece Screw
(C) through Legs frame 1 (1) into Back (3). Insert 1 piece of Screw (B) and 1 piece Screw (C) through Legs frame 2 (2)
into Back (3). Tighten using Allen Wrench (D).
6
7
x2
B
x2
D
CD
B
3
12
Put the Seat Cushion (6) into the assembled chair as shown.
x2
C