modway EEI-3424-NAT User manual

Hardware:
Component:
ABolt M6x40mm
x 8
COFFEE TABLE
DAllen Wrench M4 x 1
BScrews x 4
CScrewdriver x 1
2
3
1
1. Top Table
2. Left Frame Legs
3. Right Frame Legs
4. Support Wooden
x1
x1
x1
x2
4
4
Page 1 of 3
Before you start, here are some helpful advice:
We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
Owing to the size and weight of the coffee table, we recommend that it is assembled by two adults,
on a carpeted or padded area, in the room that it is intended for. Approximate assembly
time: 30 minutes.
Please do not use any tools other than those provided or recommended in these instructions.
Please do not throw away any of the packaging or instructions until you have checked all
the components and hardware and the furniture is fully assembled.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary
to tighten the components from time to time, so please save the tools that have been provided.
Please keep all pieces out of reach of small children.
1.
2.
3.
4.
5.
6.
Thank you for purchasing this COFFEE TABLE.

Page 2 of 3
COFFEE TABLE STEP 1:
STEP 2:
Please put back side of Top Table (1) on a carpeted or padded area.
Insert the Support Wooden (4) into the metal hinges or metal support one by one through the drilling hole.
4
1
4
1
4
2
3
4
Carefully insert the tenon on Left Frame Legs (2) and Right Frame Legs (3) and into the rabbet on Right
Frame (4) and Support Wooden (7) as shown.
1
1
2
2
3
3
5
5
4
4
6
6

STEP 3:
Carefully turn over the assembled Coffee Table.
STEP 2:
Ax 8
Dx 1
Bx 4
Cx 1
Hardware & Tool required
1
4
4
C
B
2
3
Repeat the same steps for Right Frame Legs (3).
Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure.
Insert 4 pieces of Bolt (A) into the pre-drilled holes on Top Table (1) and Support Wooden (7) through the top pre-
drilled holes on Left Frame Legs (2).
Insert 4 pieces of Screws (B) into the pre-drilled holes on Chair Seat (2), tighten it with Screwdriver (C).
COFFEE TABLE
Assembly is complete. Your coffee table is ready to be used
now! Page 3 of 3