modway MOD-5545 User manual

MOD-5544/5545 FULL/QUEEN BED
Support Leg
Center rail
Short
Medium
Long
Open Wrench
×24
×4
×4
F
are
imately
step by step

Long Bolts (C)
Open Wrench ( ).
Open Wrench ( )
B
Nuts (D)
with
6
Support Legs (6 )
to connect it with
Double Slats 9(4).
Allen Wrench (G)
Double Slats (4)
Double Slats (4)
MOD-5544/5545 FULL/QUEEN BED
Hardware & Tool required
STEP 2:
4
4
4
7
G
C
B
7
6
Cx4 Dx4 Gx1 Ex1
Hardware & Tool required
7
7
D
Bx4 Dx4
Gx1
Ex1
G
66
6
6
6
6
6
6
6
E
E
Insert 4 pieces of into the 4 holes on Center Rail (7) as shown.
Please pay attention to the holes’direction.
Tighten by using Allen Wrench (G) and untll secure.
Take out all and place them as shown.
Attach to the Center Rail (7) by using
Bolts (C) and Nuts (D).
Do not fully tighten
Long Bolts (C) and Nuts (D) with and
Please pay attention to the holes ’
direction on the
at this step.
Tighten
D
E
E
Medium Bolt (B)
Medium Bolt (B)

C
A& C
Fully tighten
n.
4
Short Bolts (A) at this step.
Tighten Allen Wrench (G).
Short Bolts (A).
Double Slats (4)
RUubber Insets (F),
Single Slats (5)
Single SlTats (5)
G
Insert Bolts (A) into the bottom holes on the assembled Headboard ( 1 ) & Footboard (2) by hand.
Leaving 0.3~0.4inch space of the thread of Bolts (A) as show .
Insert the notch of assembled Side Rails (3) into the space left on the Bolts (A).
Screw Bolts (A) into the top holes on the assembled Headboard (1 ) & Footboard (2) as shown.
Tighten Bolts (A) with Allen Wrench (G) after all assembled.
MOD-5544/5545 FULL/QUEEN BED
G
Service modwayfurniture
STEP 3:
.
Take out
Insert one end of into .then insert them into the crossponding holes on 1 piece of
Side Rail (3) as shown. Attach assembled
to the Side Rail (3) by using
with
Repeat above for the other Side Rail (3).
Hardware & Tool required
4
4
4
4
7
63
3
5
5
3
4
A
AG
Ax16 Gx1
STEP :
5
F
and place them as shown.
Do not fully tighten
Short Bolts (A)
Bolts ( )at this step.
Assembly is complete. Your bed is ready to be enjoyed now!