MOEBE Shelving System User manual

Assembly Instructions / Wall Shelving
Strandlodsvej 42a, 1 DK-2300 Cph S
([phone], moebe.dk
Wall Shelving
The MOEBE Wall Shelving gives you full freedom to build your own piece of
furniture. Build as tall as you like, build as wide as you like.
As a modular system, Wall Shelving is built entirely from individual parts. It
can be customised and adapted again and again.
All shelves are held in place by 2 wedges in the inner corners. The
combination of the wedges and the smooth legs allows the shelves
to be positioned wherever desiered, without any limitations.
Care instructions
For care instructions, please visit moebe.dk

Strandlodsvej 42a, 1 DK-2300 Cph S
([phone], moebe.dk
Assembly Instructions / Wall Shelving
2
Mark and drill holes for the two upper
mounting clips. These holes must be lev-
eled and 766 mm apart. Use an adequate
wall plug suited for your wall type.
Fix the upper mounting clips with the
provided screws.
Assemble two of the legs by screwing
the end bolts into the legs from above.
Pull the shelves up from below along the
legs. Use a water level to make sure they
are leveled. Once you have positioned
the shelf, secure it with two wedges. Tap
them with a hammer.
Water level RulerHammerDrill
Wall Shelving

Assembly Instructions / Wall Shelving
Strandlodsvej 42a, 1 DK-2300 Cph S
([phone], moebe.dk
Level the legs vertically and mark the
holes for the lower mounting clips.
Drill the holes for the lower mounting clips.
Secure the last two end bolts from below
to complete the assembly.
Fix the lower mounting clips with the
provided screws.

Assembly Instructions / Wall Shelving
Strandlodsvej 42a, 1 DK-2300 Cph S
([phone], moebe.dk
Done!

Assembly Instructions / Wall Shelving
Strandlodsvej 42a, 1 DK-2300 Cph S
([phone], moebe.dk
Lean the lower section against the wall,
mark and drill the rst two mounting holes.
These holes must be leveled and 766 mm
apart. Use an adequate wall plug suited for
your wall type.
Assemble all shelves that should be in this
section. Pull the shelves up from below
along the legs. Use a water level to make
sure that they are leveled. Once you have
positioned the shelf, secure it with two
wedges. Tap them with a hammer.
Start by installing two end caps in the
boom of each leg.
Fix the upper mounting clips with the
provided screws.
Water level RulerHammerDrill
Wall Shelving Floor Standing

Assembly Instructions / Wall Shelving
Strandlodsvej 42a, 1 DK-2300 Cph S
([phone], moebe.dk
2
Screw the connector screws as far into
the legs as possible. Add the leg exten-
sions by screwing them tight against the
lower part of the legs.
Assemble the remaining shelves by sliding
them down from the top. Drill holes for the
upper mounting clips and secure them to
the wall.
Secure the top two end bolts from above
to complete the assembly. Done!