MOFILY YoYo User manual

USER MANUAL
YoYo
Bluetooth Remote

SETTING UP YOYO
YoYo Bluetooth Remote Battery
1. Remove the back shell of YoYo
2. Insert the battery into YoYo properly.
Before using YoYo:
1. Check your YoCam and make sure it is charged
before pairing.
2. Read the YoCam quick guide to learn how
to set YoCam in bluetooth mode before pairing.
3. YoYo goes to sleep mode after 1 minute inactivity.
Activate YoYo by pressing any button.
4. It is very important to disconnect YoYo from YoCam
when it is not in use. Continuous connection might
drain the battery quickily.
GETTING STARTED

1. Press and hold the power button on YoYo for 5
seconds to activate pairing. YoYo will blink blue
and red.
2. Turn on YoCam, press and hold the wireless
button on YoCam for 2 second.
3. After the beep, press the wireless button on
YoCam twice slowly to switch to bluetooth mode.
4. YoYo will connect to YoCam and stops blinking
after it is connected to YoCam successfully.
5. To disconnect, switch YoCam to other wireless
mode (WiFi AP/P2P) or turn off YoCam.
a. If YoYo has never been connected to your YoCam,
follow these steps to pair:
1. Press any button on YoYo to activate.
2. Turn on YoCam, press and hold the wireless
button on YoCam for 2 second.
3. After the beep, press the wireless button on
YoCam twice slowly to switch to bluetooth mode.
4. YoYo will connect to YoCam and stops blinking
after it is connected to YoCam successfully.
5. To disconnect, switch YoCam to other wireless
mode (WiFi AP/P2P) or turn off YoCam.
PAIRING
YoYo goes to sleep mode after 1 minute inactivity
when disconnected. Activate YoYo by pressing
any button.
b. If your YoYo is connected to YoCam before,
follow these steps to pair:
DISCONNECTING
1. Turn off YoCam.
2. Turn off Wireless on YoCam.
3. Switch YoCam to Wifi AP or WiFi P2P mode.
4. YoYo/YoCam is out of connection range (30 feet).
Ways to disconnect YoCam from YoYo:
Important Tips:

VIDEO MODE
When LED ring is red, YoYo is in Video mode.
12
3
4
5
6 7
Short press to start/stop recording. Press and hold 2s
to start looping video. Short press to stop recording.
2
3
4
5
6
7
1Shutter
Time Lapse
Video Only
Slow Motion
Car Mode (Looping)
Mode Switch/Pairing
EIS/HDR
1Shutter
2
3
4
5
Time Lapse
Video Only
Slow Motion
Car Mode (Looping Video)
Short press to switch to time lapse mode.
Press shutter to start/stop recording.
Short press to switch to regular video mode.
Press shutter to start/stop recording.
Short press to switch to slow motion mode.
Press shutter to start/stop recording.
Short press to switch to car mode (Looping Video).
Press shutter to start/stop recording.
6Mode Switch/Pairing
Short press to switch between video and photo mode.
Press and hold 5s to activate paring mode.
6EIS/HDR
Short press to turn on/off EIS stabilization.
Press and hold 5s to turn on/off HDR.

PHOTO MODE
When LED ring is blue, YoYo is in Video mode.
12
3
4
5
6 7
Short press to start/stop recording. Press and hold 2s
to start lifelog mode. Short press to stop lifelog mode.
2
3
4
5
6
7
1Shutter
Delayed Shoot
Single Photo
Burst
Lifelog
Mode Switch/Pairing
EIS/HDR
1Shutter
2
3
4
5
Delay shoot
Single Photo
Burst
Lifelog (Continuous Photo)
Short press to switch to delayed shoot mode.
Press shutter to capture. Camera resumes to single
phot mode after capturing one photo
Short press to switch to single photo mode.
Press shutter to capture.
Short press to switch to burst mode.
Press shutter to capture burst photos.
Short press to switch to car mode (Looping Video).
Press shutter to start/stop recording.
6Mode Switch/Pairing
Short press to switch between video and photo mode.
Press and hold 5s to activate paring mode.
6EIS/HDR
Short press to turn on/off EIS stabilization.
Press and hold 5s to turn on/off HDR.

(1) this device may not cause harmful interference,and
WARNING
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(2)this device must accept any interference received,
including interference that may cause undesired operation.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.This equipment must not be
co-located or operated in conjunction with any other
antenna or transmitter.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Battery warnings:
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions
Brand Name: MOFILY
Model Name: YOYO
FCC ID:2AGNW-YOYOONE
If you have any questions, contact us at cs@mofily.com
For more information, go to mofily.com or download Mofily app.
This device complies with FCC’s radiation exposure
limits set forth for general population (uncontrolled exposure).