Monarch EZ THERMAL COVER Instruction Manual

P.O. Box 250 1850 West Adriatic Place
Adel, IA 50003 Englewood, CO 80110
[phone] [phone]
[phone] Fax: [phone]
Fax: [phone]
Self tapping screw
BOTTOM
VIEW
COVER
EZ THERMAL COVER®
Assembly and Installation
EZ Cover Installation Instructions (Read the instructions completely before installing the cover).
Materials & Tools Needed:
Check the contents of the plastic bag included
with the EZ Cover, there should be:
4 - Machine Screws Self tapping screw Nut
4 –Spring-Clips
4 –Ties
4 –Self tapping Screws
4 - Square nuts
Note: You will also need a Phillips
Screwdriver No. 2
Tie
EZ Thermal Cover Installation:
1.) Assemble the Spring-Clips and Ties as shown:
Insert the Machine Screw though the Spring-Clip & Tie Spring - Clip
Place the square nut into the Tie
Tighten Machine screw until flush with nut Machine Screw
2.) Mount the Spring-Clip assembly using the pre-drilled holes and self tapping screws. Tighten and then
loosen the self tapping screw a ¼ turn so that the Tieswivels.

P.O. Box 250 1850 West Adriatic Place
Adel, IA 50003 Englewood, CO 80110
[phone] [phone]
[phone] Fax: [phone]
Fax: [phone]
3.) Place the Cover on top of your window well and rotate the Ties and the Spring-clips for proper
alignment with the upper lip of the well.
Self tapping screw
Spring-Clip assembly
Window well
If necessary loosen the Machine screw to rotate the Spring-Clip.
Caution: Loosen the screw just enough to rotate the Spring-clip!
4.) The removable cover is held in-place by Spring-Clips.
Check egress: Pull the cover up and check the hold down.
5.) If desired, tighten the Machine screws on the Spring-Clips to increase or loosen the Machine screws
to decrease to hold down.
Machine Screw
Machine Screw