MONTISA 5003 User manual

PARTS LIST
TOOLS NEEDED
7/ 1 6 "
Wrench
T-30
Torx Bit
5/32"
Drill Bit
Hand
Drill
hellomontisa.com
3/8"
Socket
Wrench
5003
WORKBENCH DRAWERS ASSEMBLY
REV 1 6.12.2023
Image is shown with a quantity of 3
workbench drawer units ganged together.
5 0 0 3 WORKBENCH DRAWERS
Part Qty Description Image
A3 DRAWER PULLS, 3.78" CHROME
B6 8-32 X.31 PH TR HD MS
C4 1/4-20 X .50 WHIZ-LOCK SCREWS, 3/8"HEX DRIVE
D4 1/4-20 KEPS NUTS, 7/16"HEX DRIVE
E4 #14 x 1 TORX DRIVE WOOD SCREWS
Phillips-Head
Screwdriver

Montisa Customer Service
[phone]
customerservic[email protected]om
hellomontisa.com
3220 Jeerson Ave SE
Grand Rapids, MI 49548 USA
5003 ASSEMBLY INSTRUCTIONS
1
3
4
For ganging multiple workbench drawer units
together, use 1/4-20 Screws (Part C) and KEPS
Nuts (Part D).
There are (4) hole locations for ganging present
on each side panel. Remove drawers for access
to upper holes.
If installation includes a wood or laminate
top, center top surface on lockers.
Mark the hole locations for drilling on bottom
side of top surface. (4) Hole locations per
locker. Drill pilot holes 3/4" deep using 5/32"
drill bit.
***Do not exceed 1"depth for risk of breaking
through the top surface.***
Realign top surface onto workbench drawers and
install as shown with torx bit and #14 Wood
Screws (Part E).
2
Install Drawer Pulls (Part A) using (2)
8-32 x .31" long screws provided (Part B).
A
BD
CD
C
D
CD
C
EEE