Monument 1043J User manual

HYDRAULIC MANHOLE
COVER LIFTER
INSTRUCTIONS
1. Assemble Manhole Cover Lifter.
2. Clean out the keyholes of the manhole cover.
3. Fix keys into position and wheel lifter into place.
4. Pump cylinder to raise manhole cover.
5. Once cover is clear of the ground pull the lifter to move the cover.
6. To lower the cover release the cylinder valve.
ALWAYS WEAR PROTECTIVE FOOTWARE
THIS TOOL HAS A SAFE WORKING LOAD OF 1.5 TONS

ASSEMBLY INSTRUCTIONS
Slide the beam through the body
Slide lifting hooks on either side. Ensure hooks face towards the back wheel
Attach wheels and handle
Fit keys into cover and move lifter into position
Pump jack handle to lift cover
Pull lifter to remove cover

EXTRA INSTRUCTIONS
1. WEAR PROTECTIVE FOOTWARE
2. ENSURE HOOKS ARE ATTACHED FACING THE CORRECT
DIRECTION
3. IF COVER IS STUCK HIT ARROUND ITS EDGE TO BREAK THE
SEAL. IF THIS DOES NOT WORK USE A SEAL BREAKER. DO NOT
CONTINUE TO PUMP CYLINDER AS THE LIFTING BEAM WILL
BEND